Asian exclusive no fingerprints glass frosting powder

TBS-303 no fingerprint glass frosting powder TBS-303 no fingerprint glass frosting powder industrial hydrochloric acid medium, suitable for production of a sense of grit, sand caused avoid fingerprints and translucent soft Frosted glass. Such glass has been widely used in a variety of ordinary glass, tempered glass, glass windows and doors, glass sliding door curtain wall construction, high-end home decoration and high-end office furniture, and other fields. Frosting uniform quality smooth and delicate, grainy, sticky fingerprints, translucent and soft, there is a sense of grit, issued a flash in the sunlight like diamonds; Frosting yield, quality and stability, saving time and labor, the process is simple easy to operate. Frosting stable, frosting speed, not because of the influence of temperature, humidity, frosting quality. Frosting can be recycled, environmentally friendly. [Packing] 25Kg / Bag a, [Frosting preparation]: with acid ratio (weight ratio) powder Frosting: hydrochloric acid = 1: 0.5, for example: the 25 kg Frosting powder into a plastic bucket, while stirring, 10 kg of hydrochloric acid (HCl concentration greater than or equal ≥31%, do not avoid adding low concentration of hydrochloric acid or excess hydrochloric acid), the Frosting powder into plastic containers of hydrochloric acid was added slowly, stirring until evenly covered, more than 24 hours aging (aging time the longer the better), Stir several times during the make adequate response, the new configured Frosting relatively thick, the temperature drop will be cooling phenomenon, after ripening liquid viscosity temperature can resume normal use. Second, the [former Frosting Preparations]: 1, the preparation of glass cleaning liquid: water, 1 part of hydrofluoric acid 7 parts, pour-resistant plastic container, mix well. 2, glass cleaning: cleaning the glass placed on the shelves, then focus on the glass with a sponge brush wash, wipe the glass surface evenly until the cleaning fluid stays in the glass surface 5-10 seconds, then using water to glass rinse (to ensure no stains under the glass surface, so as not to affect Frosting effect) Note: Please before Frosted glass Celi 3-5 seconds, the water flow to do some, so as not to bring too much water Frosting in part, the impact of the efficacy Frosting. 3, mixing, filtration: Before Frosting Frosting liquid that has been configured with a plastic (or bamboo stick) stir until evenly, then prepare 80 mesh screen will maturation Frosting good medicine all filters once and the filtrate Rewind kits (sand with shower), residue (crystal) with plastic barrels good (After Frosting glass work is complete, the screen 80 of the crystal installed back Frosted solution to fully dissolve, so repeated operation, so residue (crystals) can be recycled, extend the life of Frosting). (3) [Frosting process]: 1, double Frosting: Frosting glass-sided, you can use the pool soaking method, the first former Frosting Frosting, stir, deposited on the bottom of the container must stir up a solid until a uniform state, and then clean the glass products into Frosting, standing 60 seconds -120 seconds, take out the back drop Frosted glass products Frosting 10-30 seconds to recover. Finally, wash thoroughly with tap water rushed to the glass surface. 2, single-sided Frosting (unwanted Frosting place with a protective film posted good) single-sided glass frosting, you can use flat sand leaching method, which is easy to operate Frosting, will be affixed to the back good protection pouring sand into glass films stand for, need Frosting side up, the Frosting evenly pour in the glass surface, Frosting time of 60-120 seconds, remove already Frosted glass products back drop 10- 30 seconds to recover Frosting. Finally, wash thoroughly with tap water rushed to the glass surface. [Add add] For purposes Frosting long-term use, use the following methods to add: the: (0.3 1): 1, not excess cleaning fluid and water into old Frosting, configuration hydrochloric acid powder Frosting Frosting concentrate, after ripening added into the old liquid, 2, excess cleaning fluid and water into the old Frosting, destroyed part of the supernatant was added maturation has previously concentrated Frosting. Note: Use every day before going to work out on the bucket hit the supernatant, the precipitate again, the supernatant was removed, the lower for the Blending. [1.0-1.5 PH value] to detect gravity Frosting, Frosting normal at room temperature accounted for 1.36-1.39. [Note] Frosting aging time and ambient temperature curing longer the best results. In Frosting process should wear protective glasses and rubber gloves as Frosting accidentally splashed into the eyes, immediately wash with water. Using hydrochloric acid concentration greater than or equal ≥31% hydrochloric acid extended Frosting efficacy and improve yield. Contact: Miss Tan Contact: 13549822798