Asian exclusive glass polishing liquid

TBS-313 Operating Instructions glass polishing liquid polishing solution for polishing glass Frosted glass, to enhance the effect of glass, no fingerprints, smooth feel, graininess can be freely adjusted by the operating time, the effect is obvious no fingerprints, no fingerprints can deepen the effect for the production of sliding doors, the process is simple and easy to operate, the glass surface polished smooth but grainy, bright, clear, leaving no flaws, the glass exudes a unique charm of artistic sense; a production claim 1, polished tank: tank size can be specifically treated glass, sink with 8-10 mm PVC sheet welded sink can be installed at a reflux liquid water to facilitate recycling; 2, due to the polishing liquid has a greater volatility sex, and the odor so large production environment require good ventilation performance, exhaust fan can be installed to facilitate the timely 2-3 exclude the volatile gas when operating in the upper tank. Staff during operation requires good protection work, wear rubber gloves and protective masks; two, the operation process 1, where both sides will not have to deal with a glass adhesive protective film to prevent the polishing liquid paste from other parts of the glass etching (such as the production design, text style required engraving machine or a utility knife to carve decorative patterns patterns on stickers, posted on the glass surface after the removal of the protective film to decorate-patterned part) is placed aside; 2, polishing liquid slowly into the pool of syrup, then soaked in syrup glass, need to be addressed side up, remember: Potion need completely immersed into the glass and up about 1-2cm, soak for 2 minutes after removing the glass (also available 1-2 minute shower uses way), rinse with tap water, after washing the glass back drop of water for 10-20 seconds (to avoid excess moisture from entering into the diluted solution of liquid inside, thus affecting the life of syrup), if end to meet the requirements, you can once again immersed in the glass polishing liquid for 2 minutes to remove the glass, the glass with tap water clean, dry can achieve the results you want. Third, the maintenance of a liquid, the liquid recovery after the operation is completed into the barrel sealed until the next use; 2, the liquid used for some time, the concentration will reduce soaking time may be extended, as ineffective , consider adding new liquid. Fourth, note 1, the operation of the workers must wear acid-resistant rubber gloves to avoid direct skin contact with syrup. 2, the operation area should be ventilated to avoid volatilization syrup surrounding environment. 3, stop production, medicine should be completely sealed, keeping efficacy. Please Yan Gean processing factories operate the above steps, if any unknown place, please call! ! 13702378374