Strong force porcelain tile glue

I. Introduction: HC-28 tile adhesive is a kind of cement as a gelling agent, adding polymer and inorganic powder surety agent, new tile adhesive binder made of, is also applicable to ceramic tiles a thin layer of adhesive. This product is formulated from high quality cement, fillers, synthetic polymers and selected additives such as a combination, 28% by weight of the water feed powder, stir 5 minutes can be used. Second, product characteristics: 1. High bond strength. High bond strength is about 2-3 times the pure cement. 2. Good workability. This product has good water retention, workability, choke crashworthiness, adjustable time up to 20 minutes. 3. The cost savings. As the thin layer of adhesive bonding powder belongs, can greatly reduce the amount of cost savings. 4. Good durability. This product has a certain flexibility and because it is a thin layer of adhesive, enhanced ability to resist deformation, so it has good durability. 5. Non-toxic, odorless, non-polluting, non-corrosive, is environmentally friendly products. Third, use: 1. Primary treatment: The base must be cleared of dust, oil, etc., so as not to affect the bond degrees. Construction of the wall to be wet (the outer dry wet) and maintain a certain flatness, uneven or rough parts smoothed with cement mortar. 2. Mixture preparation: This product is added to the water and stir into a paste, add water-based product weight of about 25%. Note that after the first turn put powder. You can use a manual or electric mixer while stirring. Stir well and stand for 5 minutes, depending on the requirements of construction consistency Add water, stirring once again ready for use. 3. Paste Methods: tooth scraper evenly scraping glue put on the work surface, the thickness of the material varies due to the brick. Usually marble adhesive should be 4 ~ 6mm, quality brick wall bond should 3 ~ 4mm, and then straighten tile rubbing pressure to the above can be. Such as tiles back deep ditch, except Face plastering outside, but also in the back of the tile plastering. Traditional methods can also be put on the back of the tile glue, then rub the pressure put right to the base, scrape off excess glue. 4. After stick tiles, it can be adjusted in time (about 20 to 25 minutes) to move to adjust, easy to correct. 5. After the construction of the natural coagulation, within 24 hours from water soaking or erosion. 6. Spices amount of time should not be excessive, with the mix with use, should be used within one hour; has been dry hardened mortar should not be used. 7. If you add too much water to make mortar too thin, adjust the consistency of the product can only add, should not add cement, sand or other substances. Fourth, packaging and precautions: This bag is attached endometrial bags, 25 kg / bag, placed in storage on pallets off the ground to avoid rain soaked, ensure ventilation, dry, avoid direct sunlight.