A new generation of special effects wall waterproofing agent (Wall drain g)

I. Introduction: HC-10 effects wall waterproofing agent (Wall drain g) is a tyranny wall leakage of water repellent, it can completely cure due to moisture, the wall leakage caused by flooding, mold or long moss and so on. The product, once after spraying (brush) wall all types of buildings, to fully penetrate the body, which form a breathable hydrophobic film layer to the naked eye can not feel the rub, when the rain or wind and percussion in the building in case of moisture, water Capillary beads will not leave water stains on the wall to fall, to prevent water intrusion, will not be closed because the base material, the moisture within the wall still radiated from waterproof film through unimpeded, to both waterproof and breathable function, so as to maintain the integrity and beauty of the building wall. Second, the product advantages: 1. This product is non-toxic, tasteless, non-polluting, non-corrosive, convenient construction, and is suitable for construction of the wall surface of a variety of groups. 2. With good moisture, corrosion, pollution prevention, anti-salting and weathering (aging of the wall) insurance primary function of the wall plays a protective role. 3. has strong permeability, water permeability, after spraying (painting) water film, rainfall or moisture can not penetrate the moisture within the wall and moisture within the wall still unobstructed through waterproof film outward distribution, achieve both waterproof and breathable and can function. Third, the scope: 1. The types of buildings facing the wall moisture, anti-leakage and pollution. 2. The garden, stone, ancient building protection warehouses, cemetery, granary, archives, museums and other moisture, mold. 3. tiles, mosaics, marble, granite and other salting. Fourth, the main technical indicators: Standard: JC / T902-2002 five construction steps: 1. Base surface treatment: construction surface must be dry, no dust, no oil, such as walls have flat-spots or mildew, flooding phenomenon should be will deal with clean, if applied mortar filled holes or cracks, quit long wet area with fans or heat forced drying. 2. ingredients of the product and water by 1: 9-10 weight or volume ratio, and can be used after stir evenly. 3. stencilled Construction: After matching paint sprayer or brush the surface with a brush in the construction directly, every construction of the base surface should be stencilled continuously repeated twice, in the first pass coating is not cured immediately the vertical direction of the second pass stencilled. 3-6 hours at room temperature, water-repellent effect, the better a week later, were splashing water spray test after 24 hours, if there is to deal with the parts of the water-absorbing traces fill spray process. Such as tiles or marble wall finishes should pay attention to the joints between bricks, the best brush or spray more carefully again to leak brush. 4. Construction conditions: not be in the rain, snow, frost in winter, air temperature and six large wind above the weather environment, construction, try to avoid the construction of rain within 24 hours after the invasion, otherwise it will affect the results, re-spray if necessary. 5. The amount of material: liquid per kilogram of product can be sprayed wall 30-50㎡ VI Notes: 1. Construction surface must be dry, the ingredients should not add too much water, and after the coating liquid ingredients should be used in the same day, or lose effect. 2. This product should be sealed and stored in a dry place not below 0 ℃, the shelf life of one year. Seven, product packaging: The packaging was 4 kg / cans, 10 kg / barrel, 20kg / barrel, 25 kg / barrel, 50 kg / barrel