SBS modified bitumen coating

I. Introduction: HC-13 SBS modified bitumen coating waterproof coating is a leap in the market, both with SBS modified bitumen membranes good weather resistance, water resistance, stability, etc., and easy to shape to an integral waterproofing membrane, is the ideal waterproof material. The product is asphalt-based materials, polymer modification, and plasticizer and filler made of high-performance, low price of thick paint. Second, product characteristics: no "three wastes pollution", tasteless, cold construction, high efficiency, low cost, eliminating solvent-based coatings construction defect fundamentally, greatly improve the working conditions; the surface after construction in order to form a complete unified whole, to overcome the shortcomings of the construction quality with hot asphalt temperature changes, stress concentration coating rubber particles excite a large number of silver streaks and shear zones, to better improve the coating extends resistance, low temperature flexibility crack resistance; the mother the role of powder, enhances its temperature insulation. Third, the scope: This product is used for roof caulking, rubbed board, old roof repair, underground waterproof, toilet seepage, wood preservative, paved roads. Fourth, packaging and storage: 1, packing: iron or plastic barrels packaging, specifications for a barrel 2 ~ 45kg. 2, Storage: 5 ~ 35 ℃ is appropriate, in a cool dry place, storage period of six months. 3. Transportation: Available railroad, marine, automotive and other transportation; prevent sun, collision, away from fire. Fifth, the construction method: For tire cloth reinforced when, recommends a four-coated cloth. 1, the base surface treatment: base surface must be flat, dry, no water, clean and free of debris. 2, the film should be divided over the coating, must not once painted. 3, should be over before the dry film coating before paint painted again later. 4, laying the carcass reinforcement, roof slope <15% can be laid parallel to the roof; roof slope> 15% should be perpendicular to the roof laying. 5, the carcass long side lap width of not <50mm, the short side lap width of not <70mm. 6, with two layers of carcass reinforcements can not perpendicular to each other on the lower laying, lap should be staggered, the distance should not be less than the width of 1/3. 7, gutter, gutters, cornices, pan outlet and close the first facade coating waterproof layer should be painted many times or sealant seals. 8,1mm thick coating amount: 1.7 ~ 1.9kg / square meter. VI Packing: 50 kg / barrel