Automatic straw charcoal, straw charcoal, blue sky machinery has been certified

When the latest straw straw charcoal equipment forming mechanism for controlling the amount of water, there are strict requirements, how much water is directly related to the success of charcoal making. The correct way to use a raw material grip and release the clutch, to observe the sawdust is spread out, if all together adhesion legend humidity exceeds 12%, is unfit for charcoal, because the water is too unfavorable for molding, charcoal surface will crack. Automatic straw charcoal equipment in proper grasp straw outside the control of the water on the furnace temperature carbonization charcoal equipment also guarantee the achievement of a high carbon content and smoke-protection mechanism charcoal production process within a reasonable temperature range and quality. Straw charcoal prices. Straw charcoal blue brand energy efficient equipment in the production process, since the operating problems or molding technology is not good enough grasp of straw charcoal machine has not led to great phenomenon. Automatic Straw rods machine charcoal equipment not stick because: 1, raw humidity. 2, the temperature inside the bar too high. 3, propeller angle not soldered. 4, spiral trough clamp the material. 5, the inner liner wear. 6, the voltage is too low. Solution: 1, dried materials. 2, machine preheating temperature controlled at about 350 degrees. 3, the pusher cylinder with forming a gap of around 2 mm. 4, repair propellers, remove debris. 5. Replace the inner sleeve. 6, check the voltage. Rod problems not under normal circumstances, should be the first consideration is not this look a few questions, then symptomatic solve the problem, it can normally produced. Most professional straw charcoal manufacturers. 4.17 Blue Sky brand straw charcoal burning charcoal production equipment length of time, which is related to the raw material and the degree of charcoal, charcoal carbon content is higher, the greater the heat, also requested charcoal in contact with air in the combustion area, combustion area is small in order to extend the time. How much straw charcoal. Straw charcoal charcoal equipment to improve burn time: 1 to improve the system of rods forming pressure to raise the rod density and strength. 2, by increasing the kiln final carbonization temperature, and slow down the heating, cooling speed, so that out of the finished high-density, high hardness. Straw charcoal production line. 4.15