Liquid silicone silk screen trademark silicone mold

Specialty Silicone AM-6106T a screen. Specialty Silicone Products AM-6106T screen is transparent two-component high-strength, high transparency, high tear resistance, soft, strong bonding, shrinkage is small, the operating time up to 5 hours of new printing plant gum; from Germany Taiwan's new material technology joint venture (which is now widely used in three-dimensional brand trademark printing apparel printing, ribbon, silk screen printing of high-quality products). This product is a silicone silk screen printing, it can be firmly adhered to the textile, nonwovens, special silicone leather, leather and other materials surface. Printing silicone are extremely versatile, silk screen silica gel with a strong three-dimensional pattern, with soft, with textile or leather complement each other, silk screen design also has excellent peel strength, abrasion resistance, brightness; also has a waterproof, non-slip, breathable , high temperature resistance and good leveling. Silicone screen printing is a non-toxic, harmless, environmental protection, by any safety system certification, can greatly improve value-added products for the production of environmentally friendly products advertised worldwide to provide a solid guarantee. This product can be divided into the following four categories: 1. For textiles: clothing label, clothing designs, sports gloves and other stone tools of non-slip, waterproof; decorative slip footwear, socks slip: handbags, travel bags, luggage and other signs, bags and other ornaments. 2. For surface coating of leather and imitation leather. 3. For high-end electronic potting. 4. Printed patterns for decoration. Second, the characteristics of moderate viscosity, high temperature fast curing, high transparency, good adhesion, heat, water, good air permeability. Third, technical indicators Appearance A component is translucent flowing liquid B component is colorless and transparent flow of liquid viscosity pa.s 58 using ratio A:B = 10:1 operating time 25 ℃ 3h operational time plus 40 ℃ 1.5h curing temperature 150-160 ℃ 56s pull tear strength tear strength Mpa 6.1 N / mm 28 Elongation% 380 Hardness (type ° A) 35 curing conditions 25 ℃ × 24H or 60 ℃ × 2H Fourth, the use of this product will be ● A, B groups were (weight ratio) of 10: 1 with mix thoroughly, and vacuum discharge bulbs. ● curing temperature and time: 25 ° C / 1-5 hours (for reference only value, depending on the actual operation date). ● Depending on the amount, can be used after now with the current, so as not to waste plastic materials, this compound can also be formulated into a variety of pigment, mixing evenly, vacuum degassing. Fifth, the packaging of the product is packaged in 20kg / drum packaging, storage at room temperature for six months, during use other sulfur water, impurities, organic tin catalyst condensation silicone rubber, acid and alkali, phosphorus, nitrogen and organic matter may Effect of adhesive curing, the use of these impurities can not be mixed. Six transport: non-dangerous goods transport.