Wire and cable plasma processor

Product Name Wire and Cable plasma processor Model JYS-3XL category wire and cable plasma processing systems >> Overview JYM-4000 cable - sealed plasma surface treatment system consists of jet atmospheric plasma processing host, transmission mechanism, speed ratio and control units, mainly for PE, silicone rubber cable marking, rubber seal flocking pre-treatment, can improve inkjet ink and flocking layer composite force, improve product quality. JYM plasma surface treatment system is an in-line processing equipment, which enables fast and continuous surface modification materials handling, is a fast, efficient, environmentally friendly, energy-saving green surface treatment process. >> Works plasma generator to generate high pressure in the nozzle pipe high-frequency energy is activated and controlled low temperature glow discharge plasma is generated by means of compressed air plasma sprayed surface, and the object to be treated when the plasma meet the surface, resulting in a chemical and physical changes, the surface has been cleaned, in addition to hydrocarbon type contaminants such as grease, auxiliary additives, etc., depending on the material composition, surface molecular chain structure has been changed. The establishment of a hydroxyl group, a carboxyl radical groups, these groups on a variety of coating materials having adhesion promoting its role in the adhesive and paint application optimized. In the same effect, the application surface plasma treatment can be very thin coating of high surface tension, without any strong action component of other machinery, chemical treatment to increase adhesion. >> Features jet plasma flow is neutral, uncharged, and penetrated the cable will not damage the insulating layer (treated layer only relates to the surface); surface properties after plasma treatment lasting stability, holding a long time; the dry method treatment no pollution, no waste water, comply with environmental requirements; online execution processing in the production line and reduce costs; the system can be configured with four plasma nozzle, according to the line speed, processing material free matching; each jet speed can be set free protection and control points to prevent the low-speed or stop causing damage to the wire processing time is too long; with manual and automatic control modes, as well as low pressure protection; built-in fan can be emissions, conducive working environment clean. >> Specifications Equipment Dimensions: 800 (W) x1250 (H) x550 (D) mm Input Power: AC220V / 50HZ; plasma generator: 20KHZ, 600W / Taiwan (up installs 4) plasma treatment Width: 12mm proposal Adaptation line speed: 20-30m / min operating modes: manual / automatic two options of protection: protection of minimum speed: 10m / min Low pressure protection: 500Pa