Clean coal briquette binder with powder

Jian-briquette binder is made of an organic polymer is dedicated to the production of powdered coal organic binder, the product features, high strength, easy to use, to overcome the existing coal thermal adhesive made, value is low, gas production rate at the end, difficult to operate and inconvenience and other defects, non-toxic, odorless, very good adhesion and low cost. Adhesive is the key coal production, determines the forming effect and equipment selection, good briquette adhesive forming rate, strength dry, can meet the transport and storage needs; at the same time requires a simple process technology, add to dry, saving manpower and resources; plus less, low cost per ton. Jian-adhesive powder dry coal add 1-2% to reach two meters square of wet strength, cold strength 85KG, while not reducing the calorific value of coal and ash content does not increase, excluding parathion and other secondary pollution substances, comply with government environmental requirements. The advantage of using the company's coal binder ◆ Free retting process is simple, high efficiency, low cost: powder added, without retting production process is simple, short production cycle, low cost production line, less land, labor demand less subject to seasonal restrictions, reduce production costs. Cost dry process, retting. ◆ add less, high strength: continuous stable and controllable added ingredients accurately stable quality. Add the amount of 1% -2%, coal different dosage different needs depending on the use of coal volatile matter, ash content, ash melting point, the S content, etc., combined with the use of manufacturers use standard coal, through testing to determine the exact dosage ratio. Jian-coal briquette made of cold adhesive strength greater than 85kg. ◆ from coal moisture, seasonal temperature effects: dry powder from raw water was added, the impact of seasonal temperature changes affect the stability of coal quality. ◆ product quality assurance: organic polymers, neutral product, stable quality, consistent, without testing. ◆ Good molding quality: wet bar elastic, coal rods fast curing, high strength, forming rate. Broken rate drying process, forming rate of 90% - 95%. ◆ a neutral additive: no corrosion of equipment, safety and no pollution. ◆ high reactivity, high ash melting point: good briquette hot dry adhesive strength of the company made large surface area combustion, CO2 conversion rate; its components can improve the ash melting point, vapor decomposition rate can be increased, lower raw material costs . Combustion reaction is complete, return slag coke rate. ◆ mechanical wear Low: For our coal production and coal adhesives rods, briquettes, smooth surface, no clogging. Reducing wear and tear on equipment, increase production have a significant effect. ◆ forming rate: For our coal production and coal adhesives rods, briquettes, wet bar high strength and elasticity, surface hardening fast. Into the blast furnace can significantly reduce the gap between the various stages of damage caused by a significant reduction in the drying kiln damage caused by squeezing each other. ◆ high taste: the company's own heat adhesive coal 3500-4000 kcal, without reducing the fixed carbon content of coal itself, does not increase the ash did not fall low calorific value, so that strength, thermal stability at 1350 ° C or more, It is the applicability of a purely organic, environmentally efficient coal binder.