Heihe rods machine _ _ versatile new system of rods rods Machine

Four blue straw rods machine difference 1. Straw rods machine tooling up unique structure, vertical feed, will help heat: Die upward vertical fed to the granulation chamber to direct the material in place, no other assist devices. Ring die pellet mill inlet side-mounted, light weight materials into granulating chamber difficult and requires special equipment and uneven forced advance, the most important is thermal cooling granulation chamber can not restrict the transmission (gear, bearing) of life . Flat die pellet mill has two structures, although able to perpendicular feed, but there are a lot of difficult to lift the state. Mold disk rotates, the sliding-pressure wheel structure flat die pellet mill, the material easy bagging, causing feed uneven, affecting production. Stationary mold plate, roller rotation, although bagging, but produce a centrifugal force, the granulation chamber into the surrounding material flung make up granulation hole and flat hole distribution center without material pressing mold, resulting in material accumulation of uneven thickness. 2. Straw rods machine mold stationary, roller rotating, materials centrifugal, evenly distributed peripheral: then with a unique two-story high confining mold of rebound effect, natural evenly distributed within the surface of the ring mold. General ring die pellet mill is pressing wheel stationary mold rotation, no centrifugal force to speak of, the uneven distribution of the material. The flat die pellet mill although the pressure wheel rotation centrifugal force, but the die hole to force the material to be inconsistent. 3. Layer abrasive straw rods machine, multi-function, high efficiency: Die has two parts, can choose two different specifications of aperture, to produce two different specifications granular product. When pressed and good bonding materials, can be added to the high-pressure wheel and two mold production reached four times the effect. Any flat mold, ring mold is not. 4. Straw rods machine big hole mold, round wire connection, increased material travel, enhance the density: Because the die structure rods machine is stationary during operation, so when pressing a large diameter rod may be outside the mold plate aperture Port wire connection pipe, increasing travel, small size, low cost tooling, but also enhance the density of the finished product (density of the finished bar can be adjusted by changing the length of the tube). General ring mold particles machine mold plate is rotating, can not wire connected pipe. To suppress the large diameter rods, mold can not reduce costs. Use charcoal powder molding machine, charcoal production can be divided into four steps 1. After crushing the raw mill crushed into granules. 2. drying and then drying the particles through the dryer, avoid moisture control. 3. rods through the material after drying system of rods made of a rod. 4, the last after charring charring furnace, cooling is finished charcoal.