Blue sky machinery has been certified _ _ mechanism charcoal mechanism charcoal market

Blue sky licensing mechanism charcoal production, tend to be some problems because of improper operation of the operator or routine maintenance is not in place. In the mechanism of charcoal production, the most common problem is the phenomenon back to gas. The reason is because the excessive moisture in the material, the generated gas can not be completely removed from the front of the device, it is from the feed opening squeezed out, so be sure to dry the raw material before proceeding. After the produce is fed back to the gas shortage phenomenon, we should increase the height of the propeller leaves, increased feed rate. Of course, the heating temperature is too high will produce insufficient supply should also ibid similar conditions and reduce temperature or to increase the height of the propeller leaves. Automatic mechanism charcoal. Therefore, the device appears to be running in a timely manner to solve any problem, do not dragging its feet on equipment hazard, affecting production. Mechanism charcoal suppliers. 4.11 environmental protection mechanisms charcoal equipment is the main equipment to produce charcoal, charcoal production and charcoal waste material can be used, not only to solve the problem of waste material, re-use, but also to ease the high demand for charcoal in the market. Charcoal in actual use, some time because it will result in a low yield rods charring. The main reason is that in the process of charcoal carbonization caused by too much oxygen. 1. Improper ignition position: the ignition position is too close to oxygen hole in oxygen hole (kiln door) produce fire, resulting in a large number of charcoal kiln door at the phenomenon. To solve this problem is to correct the ignition position, the ignition position so close to the central body of the kiln. 2, raised temperature process too long: sometimes may be due to staff negligence charcoal kiln close time, which led to the raised temperature for too long, wasting some good already carbonized charcoal. Mechanism charcoal factory. 3, kiln flue nowhere: automatic mechanism charcoal equipment will inevitably lead to a prolongation of the flue nowhere carbonization time, so that it is bound to burn some of the multi-charcoal, so when loaded kiln must ensure that the chimney flue open . Blue Sky is a licensing mechanism charcoal sawdust, branches, rice husks, bamboo shavings, peanut skin, sunflower seed shells, furfural residue, alcohol, bagasse, corn cobs, coconut shells, coffee shells and north and south straw as raw material, crushing After molding machine through high temperature, high pressure semi-finished plastics molding of charcoal, carbonized charcoal furnace charring Serve the finished product. Automatic mechanism charcoal equipment in production, the shaft head will be subject to wear, abrasion, they would have some serious security issues. So we must find the problem solved in time, in order to avoid unnecessary trouble, affect the normal functioning of the mechanism charcoal equipment. Another is that the shaft head wear as a result of improper installation. No matter what the situation head worn shafts, shaft up to address the situation if the replacement mechanism charcoal equipment shaft head wear, not only higher costs, but not necessarily in time to buy. If charcoal equipment shaft head wear mechanism occurs in addition to replacement of the case method, we can also head to the shaft of charcoal equipment repair work. Mechanism charcoal prices. 4.11