Straw charcoal, blue brand straw charcoal equipment, automatic straw charcoal

Straw charcoal equipment production, equipment of carbon rate is our greatest concern on the one hand, according to the blue sky over the years specializing in the production of charcoal equipment is concerned, the quality of the material during charcoal and charcoal directly determine the moisture content of materials of carbon rate level. The most appropriate ratio of straw charcoal production and raw materials is a ratio of the water quality of raw materials and finished carbon material is about 3 to 1, the ratio of the carbon raw material but also because of different raw materials and water may change. Most professional straw charcoal manufacturers. In addition, energy-efficient heating coil straw charcoal equipment damage should be how to do? Replacement of the heating coil: 1. Make sure the heating coil of the same model; 2, the installation of the heating coil requirements spout heat evenly, so you can extend the life of heating coil to improve the conversion efficiency of lignin; 3, installed after the heating coil to temperature probe thermometer into the cylinder fixed position to ensure accurate control of the temperature of the cylinder. Straw charcoal production line. 4.15 Blue Sky brand energy efficient straw charcoal equipment in the production process, or because of operational problems is not good enough to master molding technique resulted in the straw charcoal machine has not stick phenomenon. Automatic Straw rods machine charcoal equipment not stick because: 1, raw humidity. 2, the temperature inside the bar too high. 3, propeller angle not soldered. 4, spiral trough clamp the material. 5, the inner liner wear. 6, the voltage is too low. Solution: 1, dried materials. 2, machine preheating temperature controlled at about 350 degrees. 3, the pusher cylinder with forming a gap of around 2 mm. 4, repair propellers, remove debris. 5. Replace the inner sleeve. 6, check the voltage. Rod problems not under normal circumstances, should be the first consideration is not this look a few questions, then symptomatic solve the problem, it can normally produced. Most professional straw charcoal manufacturers. 4.17 Blue Sky brand straw charcoal burning charcoal production equipment length of time, which is related to the raw material and the degree of charcoal, charcoal carbon content is higher, the greater the heat, also requested charcoal in contact with air in the combustion area, combustion area is small in order to extend the time. How much straw charcoal. Straw charcoal charcoal equipment to improve burn time: 1 to improve the system of rods forming pressure to raise the rod density and strength. 2, by increasing the kiln final carbonization temperature, and slow down the heating, cooling speed, so that out of the finished high-density, high hardness. Straw charcoal production line. 4.15