Advantage West Dingxing vortex muffler heater

West Dingxing rotary steam muffler ring wall heater cavity size distribution of the number of groups supporting the orifice diameter, when the steam from one of the high-speed spray outward oblique hole, cold water from each group supporting the other A small hole was shot to lead both rapid heat exchange, since the heater in the tangential direction of the rotary steam is discharged, so that on the one hand greatly reduces the steam impingement angle of the liquid to be heated, effectively reducing the Because steam shock vibration noise generated by the liquid. On the other hand tangentially rotating spray steam to drive the liquid is heated to produce the same becomes rotating, hot and cold convection more frequently, this process noise generated steam bubbles to be pressed to a minimum, and the liquid throughout the container In the rotational movement is rapidly heated. Use vortex muffler heater: 1, the product shall be immersed below the surface of at least 300mm, and from the side wall and bottom of the container is not less than 200mm, preferably placed in the geometrical center of the container. 2, the selection, the pipe diameter should be greater than or equal to the nominal diameter of the heater, when a plurality of heaters in parallel, the cross-sectional area of ??the steam pipe should be greater than or equal to all of the cross-sectional area of ??the heater and the connecting pipe. 3, vapor pressure greater than 0.5MPa (gauge pressure), the steam vacuum valve should be installed, the installation of the front filter. 4, steam pipeline near a heater at the time shall be fitted with check valve to prevent steam stop, the siphon phenomenon, leading to water backflow incident. ? 5, when the steam pipe should be securely fixed near the heater strong, to make it work to warrant the swing. 6, heaters multiple parallel, it should be distributed evenly, because the weight of large, should be supported, depending on the installation site positioning conditions. ? 7, water temperature and water level in the tank, should adopt the temperature control device and water level control instrument for monitoring and control. 8, using the heater if slow, may be the internal steam holes are blocked, remove the blockage steam heater holes cleaned of impurities and contaminants discharged from the outfall, the best of each heater once a month to clean up.