Washable foam ink, water foaming ink

Washable foam ink, aqueous ink foam what stereoscopic 3D printing ink, soft elastic, foamable a light haze concavity has a special feel with flocking effect. Rally good, washable, environmentally friendly, in line with ROHS requirements? Three of the Industry of environmentally friendly water ink foam mesh, nylon cloth, waterproof nylon fabric, non-woven, denim, cotton, leather and other materials are used in the foaming ink in the printing process: stencil (mesh 50-150 mesh) → India bottom (slab) than 6 times? → issued soak more than 2 times → Printing Ink layering two or more times → India to cover up the oil more than twice → Drying time 24 hours → foam (100 ~ 150 ℃, 8 ~ 12 seconds) using a foaming ink: 1, leather treatment agent for surface treatment of the material, mesh without treatment; 2, hardening agent for foaming system may have adverse effects, please use caution, avoid the use of cationic inks and help agent; 3, printing ink note surface wetting, adhesion, avoid no adhesion, foam height is not too high, to avoid broken off; 4, foam, high-temperature baking or pressed again not hot, to avoid embrittlement, broken, shriveled phenomenon; 5, the printing process can be baked at a low temperature platen temperature should not exceed 80 ℃; Shelf life: at room temperature 10 ~ 35 ℃, avoid exposure or frozen, stored for 6 months; Packing 200KG / barrel foaming ink Using the Operation: Material - sandwich mesh 1, using the HY water-based three-dimensional printing bottoming gold oil, add 3 ~ 5% WPN-505 water-based hardening agent, primed to be printed onto flat or easy after foaming surface is not smooth, it is recommended Printing more than 6 times; 2, foam printing ink ratio: ① high foam - water-based ink: HY26 foam pulp: water hardening agent = 100: 30 ~ 50: Do not add or add 2% ② in foam - water-based ink : HY26 foam pulp: water hardening agent = 100: 20 ~ 30: Do not add or add 2% ③ small foam - water-based ink: HY26 foam pulp: water hardening agent = 100: 5-10: Add or not 2% 3, the printing plate or layering can print three-dimensional effects, you can add HY26 foaming water-based ink printing; 4, the printed cover up the oil can increase light or fog, is conducive to wear, but the light must add 3 ~ 5% NY aqueous bright surface hardening agent; 5, after the printing is complete, naturally dried for 24 hours before the foaming.