Stainless steel plate shields

Steel shield steel shield with a good seal, to prevent iron, anti-coolant, anti-tool occasional accident. 1. durable, smooth running, low noise, beautiful appearance. 2. The steel shield suitably high-speed motion Machine Tool protection both smooth nor vibration noise. 3. steel shield means not only to protect the life guard, more important it is to ensure that the machine precision. 4. Each section steel shield guards opened simultaneously parallel and simultaneous parallel to retract, to run freely. 5. The steel shield will not make guard out of touch, there is a crash, both beautiful and improve the life of the protector plate. 6. On the basis of the original sealing tape and stamped with a layer of stainless steel plate, iron temperature to prevent burns orbit plane strain strip rub rail. Steel shield system advantages: 1, the shroud can move bursts with every piece, completely different from the general pull the cover piece after piece, extremely low noise. 2, the shell means the use can increase service life. 3, steel shield device can shield the moving speed rises 120m / min and withstand higher G value (2G). 4, steel shield means moving parallel with the shroud (avoiding the disadvantages of the general shear-type shield is still meandering). 5, can be more stable at high speed without vibration. Steel shield is formed from steel or stainless steel cold formed. We can provide the appropriate type of protection for all rail machine types (horizontal, vertical, diagonal, horizontal). Depending on the operating speed steel shield structure and rails are also different. We equipped with poly-resin or brass slider speed 10m / min below. Equipped with roller medium speed 30m / min below. Driver board, need to use between scraping plates and sucking board buffer system, aimed at reducing the impact, noise and friction. Number of section steel shield its proportions, weight and operating characteristics are important. Each block should be as long as possible, thus reducing the number of sections, in general, the maximum tensile and minimum compression ratio should be 3: (up to 10: 1) between 1: 1 and 5. When the width of the larger must fold increase lateral stability. Roof type and folding can be done, tilting of the liquid and debris can flow away automatically. http://www.tongshengfask.com steel shield: http: //www.tongshengfask.com/fhz1.asp