BL-04 Zhengzhou pipe rain test equipment

Product Description The product is suitable for exterior lighting and signaling devices, and automotive lighting protective shell. Product Specifications Function: Analog rain, splashing climate standard: GB10485 GB4208 GB / T4942 meet Level: IPX3 IPX4 swing pipe swing: ± 45 °, ± 60 °, ± 90 °, ± 180 ° hole spacing: 50mm orifices diameter: ￠ 0.4 rain water pressure: 80 ~ 100kpa test stage diameter: ￠ 600mm test bench speed: 1-3 rev / min adjustable controller: Frequency converters pressure control: meter water supply system: storage tanks, pressure pumps, throttle equipment: nozzles, through needle only several security: leakage, short circuit, motor overheating product configuration pipe rain test facilities and equipment Description: The test equipment is mainly used for assessment of electric and electronic enclosures, seals in the water after the test. Or during the trial whether the equipment and components to ensure good performance and technical condition. While products may be affected by the invasion of water during transport or use, provides a reference basis for technical standards. Applicable to natural conditions carried out based on artificial rain test, with no rain and strong wind, rain and temperature irrespective of the temperature difference between the high temperature of the specimen by the introduction of a lot of water. Rain test device placed tube structure: rain test equipment from the pendulum tube frame, swing tube drive, working rotary table, electrical control of four parts, where the stand, turntable shield, the console hairline SUS304 stainless steel plate production. Rain test device placed tube works: 1, the oscillating tube: through the motor, inverter (imported) drive reducer, eccentric mechanism, rack gear and other mechanical transmission implementation. Adjusting the frequency using the frequency of the oscillating tube (per unit time), adjust the angle by eccentric mechanism. 2, table rotation: motor driven turbine deceleration rotation, so as to achieve the rotational speed of the table. 3. Nozzle: depending on the size of the specimen to determine the bending radius of the oscillating tube. Nozzle is a removable special nozzle orifices can be replaced at any time according to requirements of the standard aperture to allow uniform droplets emitted, adequate traffic. 4, waterways: open drainage pipe rain shall consider, in the civil engineering should be considered in order to quickly discharge, no water better. Quite another to be equipped with storage tank capacity to supply the required test. The device is based on GB2423.38-90 and GB / T4942.2 / 93, GB4208, GB4706, GB7000 related technical parameters design.