LDAB bi-bending steel furnace, steel furnace Figure Landglass, LDBE curved two-way steel furnace

Water and non-abrasive material plate can be effectively washed and remove deposits. After cleaning, there may still be some hard points. Recommended practice is only at this time of sandpaper can be used to remove these nodules. With very fine sandpaper, 600 to 800 mesh. If possible, try to avoid using sandpaper to clean the roller. If you use sandpaper rubbing may cause the roller surface undulations or not round. Sand wipe roller may also affect the polishing roller surface, resulting in some being more quickly after wiping the sand nodule or deposition. If you do need to wipe sand, we must guarantee may not be introduced into the furnace dust. After wiping roller sand must be washed again. Use a damp cloth to wipe the rollers to prevent large quantities of water. Water will be fine particles into the pores of the roller and then gathered there, until the roller temperature they migrate to the roller surface. These particles are often re-warming glass furnace after the fog causes. After cleaning, the final recommendation with coarse cloth roller to remove particulate roller surface. First, Frosted glass Frosted tempered glass (frosted glass) is a homogeneous rough surface with sandblast glass or hydrofluoric acid etching glass is formed. Frosting technology can also be combined with screen printing technology to produce a variety of different patterns and designs on the glass surface for decoration, produce hazy, noble, elegant decorative effect. Frosted glass and steel-sided, we need to put into the furnace Frosted face up to avoid damage to the roller. Since Frosting surface is matte, to heat absorption enhancement, Frosted glass surface temperature rises quickly, the production time, to set the upper temperature lower than the lower part, holding the furnace temperature uniformity. In addition, quenching the windward gate height slightly lower, but also help produce high-quality glass Frosting. Frosted glass and steel double-sided, glass will have some friction roller damage, it should be avoided producing double-sided Frosted glass. If you really need to produce, it can adjust the line speed of the glass movement is small, and 5% to 10% shorter heating time. After production, with waste glass (must be clean) friction dressing roller. Steel furnace, Landglass steel furnace, LD-BC-way curved steel furnace provided by Randy machines. We are Luoyang Randy Glass Machinery Co., Ltd. (www.landglass.com) in: Luoyang specializes in: steel furnace, glass tempering furnace, forced convection tempering furnace, convection oven, dual-chamber furnace