Low-temperature hot melt, low temperature hot melt film, low-temperature heat sol Po, low temperature hot melt ..

Low temperature hot melt adhesive film known as low-temperature hot melt adhesive Po in Hong Kong, Hong Kong-low; the most advanced before lining material after the set, but also has high elasticity and plasticity of rubber, thermoplastic material; repeated use sticky unchanged; its products are also heated and softened after Characteristics of tack. Operating temperature is very low, suitable opening hours, and the characteristics of the high bond strength. Shoe plastic appearance, easy to shape deformation, and excellent resilience, good weather resistance abrasion resistance, materials green. Stereotypes when no creases, water chestnut, reduce product defect rate on a variety of materials have good adhesion, no adhesive coating. Saving energy, a very excellent maneuverability. Uses: Suitable for all high-grade leather shoes, boots, shoes, children's shoes, work shoes and all kinds of sports shoes. Specifications: thickness 0.4mm ~ 1.5mm have brown, white, water, cyan (blue) of three colors, and the sheet package available in two sizes. Range 0.4mm ± 0.05mm thickness specifications applicable general Light men's, women's, children's shoes and casual shoes 0.6mm ± 0.05mm general lightweight men's, women's, children's shoes and casual shoes, men's lightweight 0.8mm ± 0.05mm general , women's, children's shoes and casual shoes 1.0mm ± 0.05mm light casual shoes, men's, women's, children's shoes and boots 1.2mm ± 0.05mm men, women, boots, hiking shoes and special purpose shoes 1.5mm ± 0.05mm men, women, boots, hiking shoes and special purpose shoes, finding ways: according to the direction indicated by the product (ie, the horizontal direction) cutting. Cutting edge ways; using conventional shaving machine is, if necessary, add oil or (water) drip edge at the way in cutting edge machines. Forming way: material bonded interface temperature of 80 ~ 100 ℃; the activation temperature is 75 ~ 90 ℃ If hot / cold rear sleeve setting machine, set the hot mold temperature of 105 ~ 120 ℃, for 15 to 20 seconds. (temperature and time to be set according to the change of the face material and the inner lining material adjustment); If the last Californian law, temperature-side molding line heating activation system shall be set 100 ~ 105 ℃, held for 5 minutes. Wenzhou Chan Sheng Shoes Co., Ltd. Main: cold hot melt adhesive film, hot melt adhesive Po, hot-melt adhesives (Baotou plastic), hot melt glue stick, folding plastic (hot melt adhesive tablets), to help the former rubber ( former state plastic), after helping gum (gum after state), pressure-sensitive adhesive (hot melt adhesive block), chemical sheet (Baotou king), paper litter paper, rubber, Lai Sun cloth (Lixin Brazzaville), the end of cloth, latex sponge, reinforcing tape, long-fiber reinforced fabric (eyelet lining) and other shoe. Welcome customers to cooperate! This information is provided by the Wenzhou Chan Sheng Shoes network, reproduced, please indicate the source: Chan Cheng Wenzhou Shoes network or www.wzcsxc.com.