Anchor bolts special epoxy grout, grout base compressor special epoxy ..

Steel epoxy glue filling material I. Features: 1, the product is a liquid that is easy to carry out concrete repair small cracks. 2, building and structural damage, the infusion of plastic reinforced, it could effectively restore its integrity, and the appearance is not damaged. 3, non-volatile solvent, basically does not shrink when cured. 4, with good toughness and impact resistance. 5, operational for a long time, after curing adhesive strength. 6, has a good resistance to water, oil, alkali and acid medium capacity. Second, the scope of application: 1, used in pouring concrete crack repair, concrete walls, floors, basement crack repair construction perfusion. 2, is widely used in steel-encased stick steel reinforcement. Third, the irrigation reinforced plastic safety performance indicators: Performance Project performance physical properties specific gravity (25 ℃) 1.2 ~ 1.3 Viscosity operational time (25 ℃) ≥3 hours curing time (25 ℃) ≤7 days colloid properties Tensile strength (MPa ) ≥30 tensile elastic modulus (MPa) ≥3.0 * 103 Elongation (%) 1.3 Bending strength (MPa) ≥45 without brittle failure compressive strength (MPa) ≥65 tensile shear bonding capacity strength (MPa) ≥15 Steel - Steel uneven pull off strength (kN / m) ≥16 steel - steel adhesive tensile strength (MPa) tensile strength among ≥33 positive and concrete (MPa) ≥2.5, and is cohesive failure of environmental performance in line with the actual non-toxic level of hygiene requirements Fourth, the construction described in concrete: 1, steel and concrete should be surface-treated adhesive surface, steel surface rust, polished, and wipe clean with acetone, the concrete surface should be polished . 2, the B component glue according to Group A: B min = 4: 1 ratio of good after weighing into the container, stirring until uniform color (usually 2-3 minutes) to low temperatures in winter or , the B component can also be 4: 1 ratio operation. 3, each time stirring the glue quantity must not exceed 5 kg to 2 kg is appropriate. 4, according to the design requirements for infusion construction, all parts easy to lose adhesive wall with clay were sealed to prevent loss of glue. 2, this product does not belong to flammable, can be air, sea, rail and road transport. 3, light up the goods transportation, loading and unloading should be in, rain, sun-proof, can not be inverted. 4. Storage time: The glue storage for one year at room temperature, the performance did not change significantly. 5, Part B long storage process prone to discoloration is normal, does not affect the amount of the product performance and use. ************************************************** **************************** Contact: 13930123708 Li Gong