Zinc alloy zinc alloy fittings 45 degree bend joint production of various types of joint-Instrumentation

Fittings have a solid connection, high voltage capability, temperature, sealing, and repetition is good, easy installation and maintenance, safety and reliability. Generally used in gas or liquid delivery tube intermediate connector, easy to use and fast, straight sleeve type connectors at both ends have clamps, the end portion of the tube wear need to be connected, and then connect the nuts after the clamping, card Nested no self-styled good, self-sealing joints in the case of one-way valve will disconnect the connection ends of the tube without exposing the gas or liquid, good airtight effect. If leaks Check 1, 2 pipe is not inserted in the end, the nuts are not tightened 3, the outer surface of the steel pipe is not scratched or round. 4, pipe too hard. Fittings pipe end should be flush. When pre-installed, you should try to keep the coaxial tube and connector body, if the tube is too large can cause skew seal failure. Preloaded force should not be too large. Should the inner edge of the ferrule is just embedded in the outer wall of the tubes, ferrules should not have significant deformation. When connecting pipes, the tube should have sufficient deformation margin, avoiding the tube is subjected to tensile stress. When connecting the pipeline, it should be avoided by the lateral force, lateral force caused Mifengbuyan over the General Assembly. When connecting the pipeline, should a one-time good tight, not dismantle the instrument instrument fitting _ _ joint production of various types of zinc alloy fittings 45 degree bend instrument instruments provided by China. Joint production of various types of instrument instrument fittings, Straight thread fittings Zhenjiang Instrument Instrument Valve Co., Ltd. (www.zjdqyb.com) 2014 has been newly upgraded launched