The new deflection tester manufacturer Arima teach you to use the new method of deflection device

The new deflection tester Uses: This product is mainly used to detect shaft, disc-type parts of the radial runout and face runout. Features: with a pair of Morse 4 # hard top, a deflection device to improve measurement accuracy, increased to support the weight of the tested parts, precision parts to measure the radial end face and oblique runout. Table frame design compact and reasonable, top to bottom, front, left freely adjust smooth, easy operation, good steel table frame, improving the detection sensitivity of the instrument. Measuring length: 300mm (A03) 500mm (A05) 1000mm (A10) new deflection tester main technical parameters: 1, the radial rotary precision 0.001mm 2, the side rails over the entire length of the two sharp edges of parallelism 0.005mm (A03 type), 0.008 (A05 type), 0.02mm (A10 type) 3, the part is the maximum diameter of 250mm 4, the part is the maximum length of 300mm 500mm 1000mm equipped with equipment: Indicators: torsion spring, dial gauge, one hundred points table. The new deflection tester Usage: Tighten the eccentric shaft, the first fixed tailstock instrument seat in fixed, according to the measured length of the part of activities leading fixed in place, pressing ball handle, into parts, with two Top told parts center hole. Fasten the handle of the top fixed. The activity table seat in the desired position, with the dial indicator (micrometer) can be carried out testing. More Related Products: After milling grinding instrument | geometric error measurement instrument | deflection tester more related products please visit: http: //www.huayuliangyi.com/