2011 Hot Products green ink four colors multi-ink color ink leather ink

Fortunately thermal ink (PLASTISOL) operations, applications, and performance of solid ink English as PLASTISOL, also known as the plastic melt ink, oily glue; is a non-solvent-based inks. Appearance and Composition: Appearance: paste ingredients: resin (solvent-free, water), pigments, and other additives, 100% solid content Features: thixotropic, denser when you place, stirring becomes thinner, summer relatively rare, Instead winter applications: 1, suitable for hand printing, machine printing can be printed Ko-color, graphic, three-dimensional rectangular, round, stone, bark effects and other special products. Under thermal ink not dry at room temperature, and heated to 1500C-1800C 1-3 minutes to bake the ink completely cured! After wet cleaning of plastics firmly attached to more than 5, more than four dry rub. 2, the absorption heat is a process, is determined by two factors temperature and time, high temperature short time, low temperature required a longer time, but the temperature is not lower than 1500C. In order to increase the efficiency of delivery is usually, the temperature is selected 1650C ~ 1800C. The simplest way to detect whether ink curing: Ink is flexible after curing, surface scratch can not afford to powder, scraping is not bad; otherwise explain plasticizing temperature is not enough, adjustment shall be based on the original superheat temperature increase plasticizing temperature and then the appropriate time. 3, glue bead craft: Fillet transparent thermal ink (oil beadbond pulp) suitable for bonding plastic beads. Adhesion fastness wet cleaning, dry-erase up to four. (Washing machine wash 45 degree continuous 10 hours does not fall off!) Would take advantage of the wet Sprinkle fillets printed plastic beads on cloth, 160 degrees, after drying or pressing machine pressure 8 to 15 seconds to 150 to 160 degrees. Scope: plastisol ink (PLASTISOL) suitable for 100% cotton, cotton / polyester blends, polyester, depth of color fabrics, denim and other fabrics where the fabric meets the following two points can be used: 1, the ability 1500C ~ 1800C ; 2, permeability, can penetrate the ink. Unsuitable substrates such as: plastics, metals, glass, etc. and water-repellent nylon cloth. Failure and exclusion: a possibility of causing poor fastness: 1, yet the thermal ink drying completely cooked guidelines: The baking temperature increase or extend the baking time. 2, cloth hair too Guidelines: When printing a first printing plate firmly 4-6 knife (use a hard side cutter ideal), or dilute the ink suitable to play once or twice a bottom and then some relatively thick ink stamp surface. 3, the ink solvent was added diluent guidelines: If the ink solvent diluent was added after the baking surface of the cured ink, but it will appear in the middle ink powder, use solid ink thinner can. Second, there is no reason for causing the elastic or appear powdery pulp layer 1, it does not take into thermal ink drying completely cooked guidelines: The baking temperature increase or an increase baking time. Third, the resulting ink blistering Cause 1, ink is heated above the temperature exceeds 2300C guidelines: The duct temperature can be lowered more, printing of the first and second plates must take ink drying cooked, so print-out The effect is the best. 2, the ink solvent was added diluent will cause blistering guidelines: instead plastisol ink special thinner can. 3, the ink was added to the aqueous category other substances can cause blistering guidelines: Always use thermal ink toning creams. Fourth, anti-stick surface the causes and prevention of a pulp layer surface does not dry guidelines: The baking temperature according to the original basis of an appropriate increase or extend the baking time. 2, thinner excessive dosage guidelines: diluent volume control plus 8% can be. 3, the slurry is too dilute guidelines: solid ink can be heated special thickening powder to improve the consistency of the ink.