Natural aluminum aluminum antioxidant qualities of antioxidants HF-630

HF-630 anti-oxidant qualities of aluminum one, the product application: HF-630 anti-oxidant qualities of aluminum is used under normal temperature conditions and various types of aluminum corrosion resistant aluminum alloy surface passivation oxidation treatment agent which can be formed on the surface of aluminum A passivation film, to achieve the purpose of corrosion and rust, can be a protective film on the surface and the surface of the aluminum alloy is formed of sand, isolated from the air to achieve the purpose, block erosion rate of moist air, so as to ensure that the aluminum surface the effectiveness of anti-corrosion and rust color finish and qualities. Second, the product advantages: 1, the goods bath preparation easy, convenient operation, simple to manage, you can soak at room temperature, without adding equipment; 2, the agent solution is quite stable, low operating cost, energy savings, strong corrosion resistance. Third, the operation process: After degreasing washed aluminum or polished → running water → HF-630 anti-oxidant qualities of aluminum moving washed clean wash soak → → drying (drying) IV Instructions: No. Description Usage Notes 1 HF-630 anti-oxidant qualities of aluminum 10% watered 3 2 Operating temperature Room temperature processing time 50--60 seconds 4 liquid PH 1-2 5 6 container use immersion device PP / PVC tank or stainless steel tanks V. operation and maintenance: 1 , according to a bath concentration of good preparation bath, stir evenly can be used at room temperature to soak 50 seconds; 2, as the process to increase the number of pieces, using prolonged and artifacts taken bath and other reasons, the bath the active ingredient and the level will decline, and if the surface of the oil bath is not much dirty, you can replenish HF-630 anti-oxidant qualities of aluminum when slotted PH value can be, you can refer to the table provided PH value ; if the bath is dirty, it is recommended that the bath replaced. 3, for the stability of the bath, it is recommended to take MTO bath management: cases a day removed from the bath 10% of the old liquid, then add 10% of the new solution in, this ratio 10 times for every one cycle. Twenty-three cycle or four or five cycles to detect a result, then determine an optimal life cycle. 4, after soaking processed products must be cleaned, or likely to cause stains. 5, wear good labor protection when operating, if the liquid in contact with the skin, immediately rinse with water. VI, packaging and storage: 25 kg / barrel, store in a cool place for 2 years effective.