Jiangyin 303 wash-water, wash-water factory Changzhou 303

First, the nature of use: 1, LW-303 wash-water is especially the development of products for the rubber mold oxide layer and other gases that are characteristic for the residue of rubber molding, release agents, or when adding sulfur produced in the mold can immediately be removed, the mold will not damage or wear. 2.LW-303 wash-water is high quality mold cleaning agents, any serious mold dirt completely clear the moment, easy to use, not damage the mold, but also to extend the life of mold. Second, the advantages: 1, high-temperature mold direct cleaning, completely remove dirt within moments, without downtime, do not rub the cleaning process do not brush, not affecting production. Clean and bright after cleaning mold, which can improve product quality, but also improve rural production rate. 2, this product is highly concentrated water-soluble liquid, according to the extent of mold contamination, appropriate diluted with water to use, very economical and practical, directly reduce production costs, oil or mild rust can also be removed. Third, use: 1, spreading method: Use a small amount of liquid or diluent spread or smear on the temperature of the mold, wait 2 - 3 minutes will soften the dirt was free in front of wash-water is dry immediately with rinse with water, mold temperature above 95 ℃. 2, the immersion method: iron tank containing liquid or diluent, heating accounts for about 95 ℃ after soaking for about 2-3 minutes. Or directly into the mold at a high temperature of the solution at room temperature, soak for 2-3 minutes then rinse with water taken from the can. Fourth, note: 1, the product is neutral solution, wear rubber gloves when working. 2, if the hand or skin stains solution, please wash with water. 3, because it is neutral material, an aluminum mold can not be used. Plating mold diluted 1: 5 using other molds 1: 2 dilution.