NX3000 super adhesive

NX3000 Use: suitable for rubber and rubber, rubber and metal, rubber and fiber, fiber to fiber bonding. Anti-wear particularly suitable for conveyor repair and cold seamless bonding, plastic drum kits, and a variety of metal surfaces, corrosion resistant rubber gasket. NX3000 features: 1. Quality --- excellent bonding strength than the German industry standard, and heat curing adhesive with strength. (In repair and cold conveyor belt seamless bonding, it can go beyond the thermal curing of the adhesive strength) the performance of the leading global peers. 2. Convenient --- simple tools can work without the use of sulfide and other large equipment. 3. The quick --- emergency repairs, the repair that is used, so that downtime to a minimum. 4. --- reliable shelf life of four years, more than other similar products. 5. Applicable --- suitable operating temperature up to 80 ℃; safe flame retardant, while Inoue and for underground use. NX3000 to use: 1. Rubber: tungsten steel grinding plate or wire wheel fully polished (not shiny), then cleared away the dust with a brush (do not use water or chemical solvents). 2. Core: The residue worn, weaving mill and then light (be careful not to damage the fabric layer), cleared away the dust (do not use water or chemical solvents). As to retain a thin and uniform rubber, then the rubber layer light sanding, the better. 3. Metal: Remove the metal surface grease, then sand with a sanding wheel or sandblasting nx cleaners, nx coated metal surface treatment agent PR300, and let it completely dry. 4. Mix: the NX3000 with nx300 hardener 100: 4 mixing ratio and stir. After mixing it must be used within two hours or hardening failure. 5. The application may be: combine evenly coated with a thin layer of the second, there is no CN adhesive layer coating the surface of the first layer. The first layer must be completely dry, and no longer reach the degree of adhesion finger back. The second layer is dry to the still slightly sticky (with a finger back again) to the final adhesive surface. (If the second layer is too dry then apply a layer). 6. bonding: the combination of two faces stick together to avoid the wind bag, tightly fitting and compaction.