Xin Li of manufacturers Figure _AB adhesive bonding adhesive bonding alloy _ Guangxi AB

AB glue with high adhesive strength, but there are some shortcomings, such as a long curing time, hand mixing caused by uneven curing bad smell heavy and so inadequate. Currently have a fast dispensing system can be solved, this system has been popular in foreign countries, in the country is not yet universal, when most people use the traditional method of dispensing adhesive. The system consists of a plastic gun, two-component syringes, three large mixing tube components. Glue factory will use the two-component syringe prepackaged AB glue AB plastic syringes stored in the inside, when the use of a plastic gun mounted on top, and then the mixing tube connected to the top of a plastic mouth, mixed with hybrid tube inside page The two piece uniform mixing tube of glue (usually after 7 can, using mostly 17's, mixed results have been very few times with the manual), and then glue is applied to the required bonding site. When the ratio of epoxy glue AB, moderate agitation should not be too much too fast, slowly with uniform along the wall, so that the chemical reaction mix can more fully, better mobility, but also conducive to better defoamed. Pour unused plastic, non-rewind vat original packaging and impurities into the whole bucket of glue will be scrapped. Every time AB glue to 200g best, too much reaction will focus more energy, you can use the shorter time, poor mobility