Xinjiang stone adhesive manufacturers

Products Stone adhesive is formulated from polymer and inorganic silicate powder made of a variety of materials. Good physical and mechanical properties and durability, good workability, sag resistance, high bond strength. For attaching stone, can greatly improve construction quality and construction efficiency. Scope 1, the product can be used for a variety of bonding and natural stone tiles. Mainly used for vertical surfaces bonded marble, granite and other natural stone, it can also be used for bonding low water absorption and large-sized artificial stone; 2, the product is suitable for masonry, concrete, cement, unglazed tile, perlite board and pretreated (roughened) tiles, marble, granite base, can also be used indoors in a dry case vertical fa?ade of plasterboard and external plywood base (EGP) above. Features 1, the product easy to use, a water-soluble formulation, simply by adding water and stirred to use, and tiling, tiles the same way as the stone attached directly to the base surface of various materials, without ornaments and other accessories without steps, stone walls and a bottom surface drilling, fixation without wetting, no construction waste; 2, for a wide range of products, strong bond, good water resistance. Excellent durability, can prevent spalling due to freeze-thaw occurs wall, good workability, ease of construction, improve efficiency and quality, a certain development time can be adjusted at the time of paste, easy to neatly; 3 with good water retention, it solves stone finishes efflorescence technical problems arising from pollution; 4, the product is particularly suitable for bonding thin plate type, especially large-sized tiles, stone and other. Compared with the hanging method, paste stone walls reduce weight, expand the interior space, increasing the use of space, while reducing labor intensity, greatly improve efficiency, save a lot of construction costs; 5, the product non-toxic, harmless, no smell, pollution, the technical performance indicators in full compliance with national building standards JC / T 547-2005 "Ceramic Tile Adhesive" requirements. Use 1, primary treatment: removal of the adhesive layer surface grease, dust, and other loose material is not conducive to the bonding material, primer and finishing materials are not required moistened with water, the adhesive surface facing material should be kept clean; 2, the adhesive rubber formulation: Press binder: water 4: 1 ratio of about (by weight ratio) were mixed and stirred slurry was adjusted to a suitable consistency, allowed to stand for 10 minutes, during which time the mixture will consistency will increase, and then stir it back to its original consistency can be used, when the second stirring, under normal circumstances do not need to add water; 3, the paste method: sock or tooth scraper to smear mortar on the base surface On the tiles and other decorative materials rubbing pressure or rubbing on the glue stick straight, conventional paste method will also be put on the back mixing glue tiles, then rub pressed to the wall, straightened, scrape off the excess mortar; 4, at 24 hours after pointing. Performance test items test results Technical indicators present concluding original tensile adhesive strength, tensile adhesion strength Mpa 1.0 ≥0.5 qualified after flooding, the tensile adhesive strength Mpa 0.8 ≥0.5 qualified after thermal aging, Mpa 0.7 ≥ 0.5 Eligible tensile adhesion strength after freeze-thaw cycles, Mpa 0.7 ≥0.5 qualified open time, 20min adhesive tensile strength, Mpa 0.8 ≥0.5 qualified