BobrickB-517 folding shower seat

Materials: Seat - 2 "(51 mm) thick overall with 1-1 / 2" (38 mm) thick, closed-cell polyurethane foam padding installed 1/2 "(13 mm) thick plywood covered in white naugahyde (. water resistance, reinforced vinyl fabric) framework. - 18-8 304 16-gauge stainless steel satin finish fi (1.6 mm), 1-1 / 4 "(32 mm) square and 18 parts (1.2 mm). 1 "(25 mm) diameter pipe mounting flange (2) - 18-8 3043/16" (5 mm) thick stainless steel satin finish sci-fi 3 "(76 mm ??) diameter holes with three mounting screws. base - 304 heavy 18-8 stainless steel spring - 301,24 No. 17-7 type surface (0.6mm) stainless steel spot welded to the base of the guide bracket - 304,16 No. 18-8 (1.6 mm) stainless steel satin Science Fiction surface finish operations: shower seat can be folded up against the wall when not in use spring lock seat in the floor to the top of the upright position until the seat is released from the top of the wall to pull the guide bracket support system allows different installation. height and leaf FL OOR clearer and more easy to clean. When Bobrick shower seat is properly installed, the network has suf cient strength to support 360 pounds, (16 kg) with Accessible design (including ADAAG in the US) structural strength requirements. Specifications: folding shower seat should have a type -304, satin- science fiction finish stainless steel, which consists of the 16th (1.6 mm) frame consisting of 1-1 / 4 '' (32 mm) square and number (18 1.2 mm), 1 '' (25mm) diameter seamless pipe. cushion should be 2 "(51 mm) thick consisting of 1-1 / 2" (38 mm) housed in 1/2 filled with polyurethane foam cells " (13 mm) thick plywood and covered in white naugahyde (water-resistant reinforced vinyl fabric). Shower seat shall be equipped with two 3 '' (76 mm ??) -304 diameter type of installation constructed FL Angus 3/16 '' (5 mm) thick, satin- science fiction finish stainless steel; the guide bracket types is - 304,16 Number (1.6 mm), satin- science fiction finish stainless steel; and type number -301,24 surface spring (0.6mm) stainless steel structure that is on the spot-type -304, bottom heavy-duty stainless steel. Shower seat should be upright locked when not in use. Shower seat shall comply with barrier-free design (including ADAAG in the US) structural strength. Set the safety plate WALL: safety plate is mounted on a wall near the shower stool in order to properly inform the user weight limit of the seat. Properly install the security sector will ensure compliance with the ANSI standard shower seat. Permanent AF sound X Safety Board to either side of the shower seat on the wall with a minimum height of 30 "(760 mm), if the seat is installed, the board must be high enough so that when the seat is in the up position is not covered The mounting screw (4) recommended, but in double-sided tape on the back of the plate can be used for very smooth, non-porous surface mount: Security and wall represented by the S point, and two mounting Florida Angus located the bottom of the roof and floor and below the guide support. The support bracket must be positioned between the bottom plate and the guide bracket which is fixed to the front wall installation of the shower seat height must comply with local building codes for stud walls, provide concealed backing to comply with local building codes and # 14 × 2-1 / 2 "(6.3 × 65 mm) of fixed stainless steel plate, metal screws furniture manufacturers.