Glass tempering furnace, glass tempering furnace manufacturers, glass tempering furnace prices, Landglass

Randy machine glass tempering furnace, glass tempering furnace [manufacturer], glass tempering furnace is provided by Randy machines. Randy Luoyang Glass Machinery Co., Ltd. (www.landglass.com) located in Luoyang City, Henan Luoyang City Road on the 12th king, Contact: Mr. Qin cleanup order is usually successful roller as follows: 1, with a coarse cloth stove and loading Taiwan's roller. 2. Wipe with a damp cheesecloth stove and a stage of the roller. 3, using gauze wipe roller, roller perception with both hands surface. a. If smooth, then wipe again with a coarse cloth attached to the furnace. b. If not smooth or some fragments visible, start the fourth step. 4, with a minimum of water and non-abrasive pad to wash roller. 5, the use of coarse cloth towel roller and a hand to perceive roller surface. a. If smooth again with coarse cloth after loading into the furnace. b. If roughness or nodules visible, repeat step 6 before starting the steps 4 and 5. 6. If there are still rough and gnarled, with fine sandpaper, filing, or abrasives to remove localized spots. 7, using a damp cloth to wipe the roller or with a minimum amount of water to clean the roller. 8, using gauze wipe roller, and a hand to perceive roller surface. a. If smooth, wipe again with a coarse cloth, and then loaded into a furnace. b. If the remains are still rough or paraganglioma, repeat step 6. c. Once the roller surface is smooth and dry, always wipe again with a coarse cloth roller and then installed into the oven. 2.2 Measures for controlling thermal deformation temperature unevenness due to heating caused by (1) the temperature difference for the upper and lower surfaces, when the glass is bent upward, indicating that the glass surface temperature. Surface temperature should be reduced, while maintaining the overall glass heating temperature constant, an appropriate increase in surface temperature; when the glass is bent downward, indicating that the surface temperature is higher than the surface temperature, the surface temperature should be lower due to lower, while increasing the surface temperature. If at the time of adjusting the temperature, tempered steel yield and quality are affected, respectively, an appropriate extension of the heating time or reduce the heating time. (2) For the deformation temperature difference caused by the presence of glass in the middle and edge, if the glass showing saddle-shaped, indicating poor insulation or furnace temperature setpoint lower edge, you need to adjust the temperature set point edge; when When the glass bottom of the pot shape rendering, if due to historical reasons, can temporarily laying glass, the first air furnace operation, the furnace temperature is evenly distributed and then poorly; if the temperature setting issue, the need to adjust the temperature setting parameters, so furnace temperature distribution. (3) for the random uneven temperature, you need timely maintenance equipment, to avoid adverse device status, often to clean up broken glass near the temperature sensor, the temperature sensor is accurate to feel the temperature of the furnace, while the topsheet is to avoid more furnace in the same state stacked.