Extruder corn extruder feed extruder pet extruder Hebei Xingtai County, Nova Machine ..

Extruder Series: 40506080 type extruder equipped with technical parameters .......................................... 5.5-7.5-11 power kW spindle speed (rev / min) ..................... ..................... 350 jacket temperature (℃) .......................................... 40 nozzle ............................................................ 12040 type yield (kg) ................................................ 20-3060 type yield (kg) .......................................... 50-60100 type Yield (kg) ................................................ 70-80 installation and use 1, with square wooden or channel, made according to a rectangular base extruder and motor foot holes the size of the extruder and motor fixed on the base, hang up and tighten the belt (B-belt). 2, before using the first nozzle removed, and the screw thread in the nozzle head, put some oil, re-tighten the nozzle to close the front flange, rear flange shaft rotating light without gaps as well. 3, before starting the preparatory 2 two wet corn (soak for 5 minutes). 4, power idle half a minute, if no abnormal sound, you can put wet corn grain by grain into the machine, pay attention Do not start cutting too fast, so as to avoid returning materials or movement killed, when spray issue pa popping sound, popcorn can be crumbled by hand, you can replace the dried corn, and gradually increase the feeding amount, under normal circumstances, the same output per hour produced according to the same model. 5. In the event of returning materials because cutting too fast, not enough is nozzle temperature of 120 degrees, then you should stop cutting, the feed hole with a little water, plus material with a wooden press, to make flower spray can continue cutting When cutting flowers ejected after cutting to a small amount, so continue charging temperature is normal again. 6. ejected flower coke burnt phenomenon because the internal temperature is too high, can be used wet towel wrapped around the nozzle to make it cool. 7. ejected flowers are hard core, due to the lower internal temperature, should stop cutting idle for a while, to be ejected flower normal after cutting. 8, work in a sudden power failure or other emergency stop situation, should immediately remove live twist nozzle, the jacket and the screw till the fire scorched more than expected to separate the screw and jacket, being careful not to burn time off long, so as not to damage the jacket and the screw, such as discharge nozzle down, do not hit hard, you can remove the nozzle and the jacket together in the fire to boil. 9, when the normal shutdown, you should first stop cutting, loosen the nozzle and then shut down, out of the screw, remove excess material, coated with cooking oil to prevent rust. Our country has multiple sales, after a fault to the factory maintenance dedication to customer service Our long-term supply of spare parts, is responsible for long-term maintenance