Supply separator, ball mill special adhesive

Widely used in a variety of ceramics and metal bonding below 150 ℃ operating conditions, coal fire power plant, milling, ash, dust removal system and smelting steel plant conveying, batching systems, hoppers, silos, wear-resistant pipes, elbows, ball mill Performance Item Index Detection burnt-like visual appearance of a white viscous Mixing ratio (weight ratio) A: B = 4: 1 Density (g / cm3) 1.28 GB / 13354-1992 operating time ( min / 25 ℃) 30 GB / T7123.1-2002 shear strength (Mpa) 25.0 GB / T7124-1986 Tensile strength (Mpa) 65.0 GB / T6329-1996 curing conditions (25 ℃) 24h - Operating Temperature (℃ ) -60 ~ 150 Use 1 will be sticky surface to remove oil, dust, rust, polish roughened cleaned and dried cleaning agent. 2. A, group B according to weight ratio of 4: 1 with glue, mix the color consistency, mix thoroughly coated surface has been handled well be sticky, then fold the two contact surfaces and contact pressure is applied, 8 to 10 hours basically reached the structural strength, you can use and move. 3. This gel mixture at 25 ℃, with a pot life of about half an hour. 4. Every time with not too much glue, glue should be used as soon as possible after the match. Glue gel time and temperature, the higher the temperature, the faster the gel. 5. Avoid contact with skin, eyes, and it adheres to the skin, use alcohol or soap, then rinse clean. If it gets into your eyes, immediately wash with water after medical treatment. Package deposit transport 1. 5kg / set, 20kg / box. 2. Store in a cool ventilated place, storage period of two years. Over the shelf life of appropriate viscosity can continue to use, does not affect the final results. 3. This product is non-dangerous goods, according to general chemical transport.