Special silk screen printing ink plating panel

One-component metallic glass ink from the dry substrates: aluminum, iron, copper, stainless steel and other metals; glass, electroplating products. The final product, for example: aluminum products, iron products, stainless steel products, glass, electroplating products. Features: 1, light, aluminum and iron for good adhesion, scratch-resistant adhesive and means no loss. 2, there is a faster form of dry, about 20-30 minutes. 3, ordinary glass and iron products can be printed without overtime hardener, a special additive 1-5% Small 400599 hardener to increase the hardness. 4, high brightness, high hardness, single component, from the dry type (to bake). Usage: 1, mesh: 150-350 mesh. 2, Screen: resistance to organic solvents sensitive adhesive production network version. 3, the scraper: 60-90 ℃, solvent scraper, such as polyurethane scraper. 4, dosage: 300 per kg with mesh screen printed 40 square meters. 5, printing (prepress preparation, printing process). A) Dilution and cleaning: plus 10-20% before use diluted with a solvent ink after printing; continuous printing, intermittent printing application after washing network water. B) solvent may be used: 1, 719 quick-drying water, 718 in the dry water 783 slow dry water. 2, according to the above models can be mixed to use. C) ambient temperature: more than 1,30 ℃, a small area of ??the printed selection of dry or slow dry solvent, such as 783 slow dry water. The following 2,20 ℃, a larger area of ??the printed selection of dry or drying solvents such as 719 quick-drying water, 718 dry water (due to the printing environment, or the printing area, the need to adjust the ventilation rate effect). D) drying (natural drying time): natural evaporation drying, surface dry 15 minutes, hard work more than three hours (due to different climatic and printing environments are different). E) to dryness (speed up the drying time): Available below the temperature 120 ℃ hot air drying and drying (10-20 minutes can completely dry). F) a catalyst additives: antifoaming agents selected according to the actual situation, oil-repellent, matt agent, a curing agent. G) Adhesion test: Printing on with adhesive and no obvious means scraping off the aluminum substrate. H) cleaning screen: with an organic solvent, such as 007 net wash water cleaning screen. Note: 1, brush goods should test adhesion after 48 hours.