Production and sales of Shai Banji

Shai Banji a common specification, the main technical parameters 1, input voltage ~ 220V5% 50HZ 2, Total Power: 2.75KW copy lights power 2KW / 3KW Operating voltage:. 220V Current: 50A 3, body dimensions: length: 900MM * Width 1200MM * High 800MM 4, maximum copy size: 800MM * 1100MM / 1100 * 1400MM 5. Size: 900 * 1200MM / 1200 * 1500MM Second, use step 1, first open the cover, wipe the glass with a little glass cleaner function The two sides, wipe clean thoroughly (especially the initial use). 2, plug in the power Shai Banji 4 square wire, 220V with ground socket. 3, the main power switch is turned on, the red light is on, press the switch lights, copy lights. 4, will be copy, online version (or plate) on the glass in place, and the two sides of the suction catheter placed close to the screen (the bogey on the screen or mesh pattern plate pressing otherwise affect copy quality) or a catheter placed in the side screen, the catheter can not pay attention to pressing halftone pattern. Slowly pull down the lid locking. 5. Adjust copy time, according to the halftone patterns and different photosensitive materials, select the appropriate time. 6. After selecting the time, the exhaust? Switch is turned on, the blue slide switch to the right of the plate moving forward. After about a minute the cover is pressed against the blanket will slowly be sucked into the screen. 7, observe the ammeter needle 10A back after the exposure button is pressed, the shutter is open, so that the start date copy; sun screen time, the shutter automatically return to its original position. At this point, if the network layout is similar to the sun continued, can not turn off the lights, continuous copy for several hours. 8, after the lights, do not turn off the power immediately, five minutes after the power switch is turned off, unplug the Shai Banji. 9, once again wipe the glass, so that it remains clean. 10, after the copy lights closed to instantly turn on the lights, then we have to wait 3-5 minutes and then turn on the lights. Third, note 1, the long-term without the requirements unplugged. 2, run printer, turn on the power switch at the stipulated time. 3, to keep the face clean and dry with a soft clean cloth delicate after use. 4, to maintain ventilation and dry, not to corrosive materials together. 5, should not be placed in hot and humid place, usually placed 5-40 ° better. 6, after lights out, the time interval five minutes, and then turn on the lights, otherwise it will reduce lamp life. Fourth, the use of the models used in the light-sensitive adhesive. Film membrane, silk screen, PVC, film products, advertising, calendars, plastic, glass and electronics industries, printing professional copy equipment.