Iodine gallium lamp vacuum printer

Shai Banji vacuum suction using a manual one, the main technical indicators: maximum screen frame size 1100mmX1400mm power 220V50HZ iodine gallium lamp power 250W power 2KW vacuum pumping speed 1L / S maximum vacuum 6.7X10 Dimensions 1200 * 1500 * 92cm II. machine operation: (1) Open Shai Banji cover, power, turn the power switch, the machine red lamp lights, fans, setting of vacuum suction time and exposure time. (2) the film is fixed in a glass countertop desired location, and then coated with a good halftone sensitive adhesive on the film FIG consistent position closing the lid, press the "start" button, vacuum pump and iodine gallium lamp in accordance with the followed by a preset time work; after the end of time, a vacuum pump and iodine gallium lamp and stop working, copy completed. (3) After 2-3 seconds (deflation time machine), open the cover, remove the screen can be. If both blocks of the same nature as much sun screen, and put one or more pieces may be gumming edition copy, simply press the "start" button. Third, part of the use of the function keys (1) time setting: Press the "Vacuum 2" key, then press the number keys to set inspiratory time zone after the adjustment is completed, followed by "exposure" key, set the exposure time. (2) "Vacuum 1", "trigger" is not in use in this machine, vacuum a time can be set directly to zero. (3) "Vacuum 2" is defined as beginning from the suction process to the exposure time. (4) the "reset" using the key: In the copy process, if found somewhere improper use, press the "reset" button, the adjusted accurate, "start" to continue working. (5) "cleared" to use keys: Before After pressing to clear all the time setting. (6) Power supply voltage is 220v. Notes: 1. Unplug unused for long periods. 2, Shai Banji run to set the total open on the "0" position. 3. The need to maintain cleanliness and dryness face before and after use with a soft and delicate cloth. 4, maintaining ventilation and clean, easy to put together in corrosive substance. 5, should not be placed in hot and humid place, generally placed into 5 ℃ -40 ℃ appropriate. 6, use two consecutive intervals greater than 5 minutes, otherwise it will reduce lamp life. 7, after the copy job to heat 5 minutes before work.