Shu peeling machine stripping machine how much money a

Features: This machine is mini-straight with strippers, stripping range can cover almost all domestic 42MM following types and models of wire and cable. San twisted wire, monofilament, wires, closed-circuit cable, network cable, including armored cables, high voltage cable insulation, etc. can be easily peeled off the skin, greatly improving the efficiency of the separation of plastic copper. This machine is upright with double blade twin roll roller design, the motor is a Shanghai company, GB 2.2KW motor, powerful (one year replacement new motor). Double blade designed to enable users no longer at low temperatures Insulation stiff difficult to peel and frustration. The machine into the line hole 21, in which four smooth cutting a hole, two separate holes monofilament rolling, two flat wire holes, three twin holes, 10 round holes (5 pole feed empty), optional a wide range. New machine bottom axis adjustment bolt, the peeling effect is more good. Instructions: 1, start the motor, check functioning properly, the feed view the size of the file Outsourcing rubber cable diameter, followed by root feeding. 2, in order to be able to insert long-term durability, should feed the rubber cable connector cut, in order to avoid chipping blade gap. 3. If, after feeding it appears too deep and yarn breakage, pay attention to the following conditions: ①, should adjust the feed file that is on both sides of the blade Axis M12 screw pressure tightness; ②, in the feed to check whether the location misplaced ; ③, is new for the blade, cutting edge is too sharp, the application-specific Whetstone little trim, modest so far. 4, if the feed out later, rubber has been stripped, but copper can not spit. There are four points situation: ①, the shaft knurled too deep, application-specific Whetstone will be grinding on the shaft, but not too much grinding, grinding likely to cause too much oily hard drive cables; ②, spring pressure is too loose, you should tighten the pressure, can spit lasts; ③, wire diameter is too small, or the vertical axis gaps ones, should be raised to two-axis clearance 0 4 --- 0 6mm;.. ④, processing Rubber cable has fever, copper can not spit. 5, if the feed pressure profile agent can not drive past the cable, expected to stay in the middle, the case appeared in the following situations: ①, check the file if there is slack in the belt; ②, check the stalls on both sides of the spring pressure if too tight, not the top power, should relax the pressure; ③, cable oil too much, so that the two shaft slipping, should always be two shafts dry, (when dry, if the machine in operation, please pay attention to safety).