AET waterless coolant

WF-26 waterless coolant general car average fuel consumption of about 12 liters / 100km fuel consumption of 600 liters per 5000 km, using AET water cooling fluid, reduce fuel consumption 10-18%, that is, within each maintenance mileage savings 60-108 liters of gasoline per liter petrol five yuan terms, total save 300-540 yuan, 150,000 km approximately 9000-16200 yuan can be saved. About 15 percent while enhancing power, reduce maintenance costs by more than 80%, more than 2 times longer engine life. Description: water cooling fluid is a non-aqueous, high temperature fluidity, good temperature performance, high boiling point, low freezing point, no scale, no "boil", non-corrosive, non-pressure, non-scaling and other characteristics; for tanks, engines, pipes and pieces of rubber has a protective effect, for a variety of gasoline and diesel engine cooling systems and related industrial cooling cooling system. It is the traditional automotive coolant replacement products, is a major breakthrough automotive antifreeze cooling technology. Non-toxic safety, environmental protection and energy saving. ● Product performance: ★ no water does not boil. ★ freezing up to -50 ℃, the boiling point of up to 185 ℃. ★ rust, cleaning, no corrosion. ★ enhance the power and reduce fuel consumption, reduce noise. ★ once added value to enjoy. ● Instructions: 1. Remove the cooling system for each line interface to the car, put a clean coolant. Air cleaner and deputy tank put together the water clean. 2, using water repeatedly washed the entire cooling system, using compressed air into the pipe in the cooling cycle, the water forced out, which is very critical. 3, also can quickly remove water AET perfusion liquid to start the engine hot car (by the rapid removal of water fluid circulation within the television professionals to reduce the water content in the pipeline) Remove the screw again, the line was the rapid removal of water put the net, such as Each aluminum, iron fittings and hoses severe corrosion and aging are required to be replaced. 4, with extension tube heater tube from the front office to install water cooling fluid, until the liquid flows from the tank lid at (this installation in the shortest time to exhaust internal air cooling system) is mounted tightly all water, start the engine hot car exhaust air (no need to go out to test this procedure, directly in the workshop). 5, electronic fan rotation, check the water temperature is normal, with or without heaters, leak, mount warning labels. At this point the entire process is completed. Note: After you change the water cooling fluid can not add water or other coolant, because it will affect the play the best performance of the product. When they go out as the engine temperature was found higher than normal temperature, stop and check whether they have enough coolant (engine coolant temperature is high enough to be one of the causes), as at this time there is no water cooling fluid on board, you can add Some pure water to meet their urgent needs, then when conditions then completely replaced the coolant water cooling fluid, restore the original car performance. How it works: 1, United States AET water cooling fluid, water-free, high boiling point, low freezing point, no pressure, no heat barrier entirely caused by steam, with thermal capacity of water three times faster than the engine operating temperature to a perfectly balanced overall engine performance rise. 2, the traditional coolant water, a lot of water vapor at high temperature to form a gas cylinder peripheral level, causing the engine overheating, the engine's performance.