Brake chamber

1. The spring brake chamber assembly, the diaphragm chamber and spring chamber composed diaphragm chamber air intake for brake, spring chamber for the parking brake, or emergency brake, ending in a release bolt group, a spin when gas path fault The bolt can be lifted out of the spring brake force. 2. Press the release bolt brake chamber spring brake releasing state group is attached to the vehicle, the mounting bolt tightening force 180N.m, according to general brake chamber is connected to adjust the test routine adjust fork After location, again spring chamber inflated to 0.55Mpa, twist the release bolt to the bottom and 35N.m force to tighten. 3.30 / 30 pairs film brake chamber, supply is released bolt group fixed on the body, When you need to remove the component into the back of the hole strong spring tension to release the spring braking force. Loosen the big nut to release the spring pusher braking force 4.ZM440 need. 5. Use the two chambers is prohibited At the same time used to adjust the arm, in order to avoid overloading the brake below the belt. 6. No special tools clamping tools can not easily removable brake to avoid spring out of wounding and Zhidongshiling sales manager Zhang 18266775698, QQ2197113155, for your dedicated service.