Jining trailer brake chamber

Loaded adjustment: spring brake chamber is connected by two screws on the frame, fork and adjust the arm connection. Adjusting the initial position  adjustment arm through the front fork and push rod is connected via the rear adjustment screw nut relax piston stroke and spring preload. Caution  ⑴ cavity with strong spring preload.  non-professionals without special equipment and special tools shall not be demolished. ⑵ product should be checked prior to installation  product should be no reason to fall, hit, hit, etc. deformation, damage caused by such phenomena. ⑶ should be checked before installation of the gas line blocking, leakage, bad and clean  should also check the adjustment arm and the brake shoe. ⑷ bracket bolts should be tightened. ⑸ piston, push rod stroke adjustment is appropriate. Supply brake chamber spring brake chamber T30 T24 brake chamber diaphragm chamber brake chamber housing and the cover is made of steel stamping, with clamps, bolted together to form the entire case between them fitted cloth rubber diaphragm, the diaphragm entire housing is divided into two completely isolated from each other chamber. Chamber between the diaphragm and the cover through dual-chamber brake valve chamber between the diaphragm and the housing often through the atmosphere. When the free state, the diaphragm and the cover close, while the other side is in contact with the disk putt on the return spring mounted between the disc and the end face of the housing, push rod and the other end connected to fork equipped with to connect the brake adjustment arm. Entire brake chamber bolted in a special bracket. Tel 18369723067 QQ 2821325443 supply tight rope tight rope, wire rope tight rope, dual tight rope tight rope Supply Manual, Auto Parts tight rope