Shandong CUT-100 Inverter Plasma Cutting Machine

Advantages LGK series of air plasma cutting machine: that plasma arc energy is more focused, higher temperature, cutting speed, small deformation, but also cut stainless steel, aluminum and other materials. Plasma cutting arc downside is that strong, noise, dust, pollution of the environment has some of the many thick underwater plasma cutting, cutting thickness also has some limitations. Similarly, the gas flow rate, arc length, cable quality, current size, cutting speed all affect the quality control is not good nor buried think, as flame cutting simple. Plasma cutting torch is not appropriate, because the cutting speed, subject to the above-mentioned factors disharmony, the cutting quality is not the same. In general, sheet cutting, plasma cutting cut surface quality is better than stuffing fire cut exploration, and rarely dross. Therefore, the use of plasma cutting 4-30 mm steel plate is the ideal way to avoid cutting the lack of oxygen B slow deformation, cut Rong serious, dross serious shortcomings. Obtained under a certain thickness of the stainless steel material and other materials. LGK-100 / CUT-100 plasma cutting machine Description: 1, plasma cutting machine control circuit using integrated circuit (transformer), the control program is simple and reliable, low failure, easy maintenance; 2, convenient operation and can be used with or without contact pilot mode; 3, cutting arc stability, cutting speed, cut smooth, small deformation, less slag, save material; 4, plasma cutting machine safe and reliable, using compressed air, eliminating the need for expensive gas; 5, cutting carbon steel, stainless steel, aluminum, steel, copper and other metals, and can be cut to any line in a variety of locations; 6, the air plasma apply to vehicles, shipbuilding, chemical, boiler, food, medicine, kitchen, environmental protection and household appliance industries machining. The series of air plasma cutting machine is equipped with a compressor flow should not be less than 300L / min, the pressure is not less than 0.8Mpa (0.35-0.5 best) Model:. LGK-100 / CUT-100 Rated input voltage: 3-380V frequency : 50 / 60Hz Rated input capacity: 27.7KVA rated output current: 100A Duty cycle: 60% Air pressure: 0.5mpa (equipped with a compressor flow should not be less than 300L / min, pressure of not less than 0.8Mpa) with air compressor : greater than or equal to 0.2m3 cooling air style: forced air cooling Dimensions: 710 * 430 * 800 Weight: 130Kg Maximum cutting thickness: stainless steel, carbon steel, cast iron: 30mm aluminum: 20mm Copper Alloy: 16mm copper: 10 Ni: 15 (This series of products best cut thickness of 50% -70% of the maximum cut) LGK series of air plasma cutting machine standard factory standard set: a cutting torch, ground and ground clip, trachea. Customer-owned air compressor, cutting work can be carried out after installation.