Xi'an anti-static table, lighthouse table, custom table line

Antistatic worktable generally consists of anti-static high pressure decorative laminates ??? (commonly known as the anti-static film HPL) is made of a conductive substrate surface material. A conductive substrate is generally conductive particleboard or graphite composite panels, so the table with anti-static properties. Static electricity can be directed toward the ground by anti-static floor or ground. 3 advantages of user-friendly design, ergonomic, comfortable and beautiful, improve production efficiency modular design, a variety of accessories optionally any combination, and having interchangeable modular design, according to different requirements, customized products you need quality countertops, use anti-static fire board, with double-sided overall anti-static, fire prevention, wear-resistant properties supporting steel structure optimization design and high quality cold-rolled steel production, durable metal surface acid, phosphate processing national electronic industry standard SJ, using high-quality anti-static high-voltage electrostatic powder coating, smooth, beautiful and overall anti-static, to prevent electrostatic potential threat to the product fundamentally [1-2] 4-point resistance test bench test surface shall comply / T10694- 2006 regulations. When the test bench static leakage resistance, an electrode pad good contact with the other electrode (clip) and bench grounding wire (or wrist strap jack) connections. 5 Install 1 to determine the size of the anti-static mat according to the required work. Wash thoroughly with alcohol pad lower surface and the upper surface and the components. 2, anti-static mat laid under the surface of the foil, aluminum foil only allowed lap in the fold. From the anti-static mat positive pressure knob fitting can use other nut instead it through the foil pad and ensure good electrical contact. 3, will be ready static anti-static mat ground floor flat on the work surface. The scope of activities determined in accordance with the operator's placement area of ??anti-static mats. The table placed anti-static mat. 4, anti-static safety workbench ground, with cross-sectional area of ??not less than 2m㎡ stranded copper conductor cord or cable from the anti-static mat and mats 1M resistor connected in series, respectively, to configure the system on the ground. After the installation is best to check to check before using.