Supply level gauge magnetic level gauge Level Meter

Total Column magnetic sub-level gauge is to measure the magnetic sub-element, magnet drive turned columns display, without energy. Two or more of the same container measurable medium level. Suitable for low temperature to a high temperature, high pressure vacuum to a variety of environments. Oil, electricity, chemicals and other industrial sectors ideal level measurement products. The magnetic sub-level gauge configuration, limit switch outputs, enabling remote alarm, detection and control. Magnetic sub-level gauge configure the transmitter, it can achieve the level of remote indication, detection and control. Depending on the installation position of the container, to provide two forms of side-mounted and top-mounted. Depending on the working medium, with stainless steel and ABS plastic two materials, including ABS is particularly applicable to acid, alkali and other corrosive media. Second, the structural characteristics of the basic type level gauge based on the principle of buoyancy, the float in the measuring tube with the level of lift and move up and down, the permanent magnet inside the float by magnetic coupling, drive red, white turned columns flip 180. When the liquid level rises, the column turned from white to red, from red to white when you fall, in order to achieve the level of instruction. Use upper and lower switching output type magnetic float level with the move, so that ON-OFF control or alarm installed in the reed switch action level meter riser set position to achieve. Electric remote mount the transmitter on a magnetic sub-level gauge. Transmitter consists of two parts, consisting of sensor and converter, which move up and down through the magnetic sub, magnetically coupling the inner conduit pieces measuring no action in order to obtain a resistance signal change is converted into a standard 4 ~ 20mA current signal output for use with Digital display instrument or computer connection, to achieve remote display. Third, the main technical parameters of the installation in the form of content side-mounted roof-mounted installation spacing (measuring range) 500-6000mm 500-3000mm Working pressure 0.6,1.6,2.5,4.0MPa 0.6,1.6,2.5MPa medium density ≥0.5g / cm3 ≥ 0.76g / cm3 stainless steel flange connection DN25 Flange DN200 ABS DN25 Flange DN200 Body Material ABS (working pressure 0.6MPa) 1Cr18Ni9T medium temperature -40 ℃ ~ 100 ℃ (special build up to 240 ℃, ABS: -15-60 ℃ ambient temperature of -40 ℃ ~ + 70 ℃ indication error ≤ ± 10mm medium density ≤1st (10- 4 m / s), the lower limit switch output 1. Control Sensitivity: 10mm 2. Output contact capacity: AC220V2A 3. Contact life: 5 × 104 electric remote continuous display 1. Accuracy: ± 1.5% 2. Output load: 750 3. Output signal: 4 ~ 20mA output, 24VDC wire system * Note: Side-mounted stainless steel, the Measuring range = mounting pitch. When using ABS material, the measuring range (display range) = installation spacing L-150mm.