Humidifier automatic dispensing line

UV tunnel furnace humidifier device a program book, design requirements Second, the design process planning three or four program design, equipment technical parameters of five, dispensing valve of one, the design requirements of 1.1, Size: 1.2, dispensing location: Humidifier Dispensing closure; 1.3, the technological requirements: strips to continuous, without interruption; and not excess glue, after dispensing products air tightness. 1.4, capacity requirements: unloading dispensing time 15 S, the theoretical value: 3600/15 = 240PCS / H (XT-441 models) 240 * 2 = 480PCS / H (XT-551 models) Second, the design process Planning fixture plate material, the plastic material in place points finish, Z-axis homing goods loading and unloading, the Z-axis dispensing product lines, enter the UV oven to dry cycle Z-axis dispensing III design 3.1, the whole design: 3.1.1 Dimensions (Unit: mm): L5210x W1265x H1456 3.1.2, the whole diagram is as follows: 3.2, a major component of the device: A, automatic dispenser B, common product positioning station C, tunnel furnace 3.3 , an integral part of each presentation: 3.3.1, automatic dispenser 3.3, an integral part of each presentation: 3.3.2, general product positioning table 3.3, an integral part of each presentation: 3.3.3A, dispensing valve IV equipment Important technical parameters 1, the plastic precision: ± 0.05g 2, machine speed: 500mm / s 3, automatic dispenser detailed dimensions diagram: 4, tunnel furnace detailed dimensions diagram: