Lifting equipment lifting handling equipment Shandong Zaozhuang Lu of choice

Commonly used in monorail hoist, jib cranes and manual single-beam traffic, because of its simple structure, easy to manufacture and repair, interchangeability, easy to operate, so it is widely used in the factory. If it's a safety device failure, improper use can cause injury or death. Therefore, in addition to the provisions of hoist operator training and certified operating outside. They must also strictly observe the following rules: (1) should be carefully checked before the start of mechanical, electrical, wire rope, hook, equipment, etc. stopper is intact and reliable. (2) shall not overload lift. When lifting, hold hands allowed between the ropes and objects. Hanging objects hit the top to prevent the rising. (3) When lifting objects, you must comply with safety rules linked rigger. Banding should be firm, in sharp objects should be located notch liner protection. (4) the use of the trailer electrical switching start line, must be well insulated. Right pushed the button, note the standing position during operation. (5) monorail hoist track when cornering at or near the track at the end, it must slow down to run. (6) Where the hoist operating room must have hand operation, strict compliance with road work safety procedures. 1 Lifting crane operating conditions must have been authorized by the state technical inspection body inspection of lifting machinery inspection reports and inspection plate; 2 types of lifting machinery use, shall comply with the factory and the detection and identification of standards, safety control unit complete, reliable performance; safety device 3 luffing crane indicator, torque limiter, weight limiter, travel limit control system should be accurate; 4 on-site assembly of lifting machinery, must be performed by qualified assembly unit assembled, the crane must have passed the test after authorized technical testing organizations, assembled for an inspection after passing the test before hanging officially put into use; 5 if purchased imported lifting equipment shall comply with the relevant provisions of the state, government departments; 6 new After the overhaul lifting equipment self-qualified prior to use location technology supervision department shall apply for security supervision, inspection, before entering the construction site after passing; 7 crane operators, signal workers, state workers and other rigging of special trades It must be certified; 8 conversion and assembly of lifting machinery banned from entering the construction site operations;