Supply production RSQ-3 Combustion Controller

 RSQ-3 burner controller is mainly used in gas, oil burners burn automatically. The burner control formulation ZWJ-306 UV flame detectors and GNQ-10 high-energy ignition and control devices. First, the use of: using two ignition control mode for automatic burner ignition, flame monitoring and fire protection. II. Control Box 1. Dimensions: 500 × 400 × 140mm 2. Installation: preparation of the corners of the box with the mounting bracket. 3. The cabinet panel Illustration: (as shown in the picture entity) III. Installation and Wiring 1. Terminal diagram: 2. connect the power cord: Press Line connector cable connected UV probe and solenoid valve control lines. Lighting rod with high-pressure high-voltage ignition cable is connected to the housing outlet, and tighten. 3. UV probe installed in the corresponding position on the burner, mounting thread of M20 × 1.5, detection channel diameter of not less than Φ18, the probe must be aligned with the flame-user installation. Lighting rod outer diameter Φ16, mounting thread M18 × 1.5, the lighting rod screwed to the installation, the lighting rod mounted on the front end combustion nozzles at 30 ~ 50mm. 4. When a small fire lit steady a certain time (time adjustable ), automatically opens the fuel valve, the fire indicator light, that means normal fire burning. Four. Operation: 1, turn on the power switch, power indicator light. 2, Ignition: The ignition switch is in the open position began firing, firing at the same time the fire indicator light, if ignition (6 seconds) fire indicator light means that the combustion continues normally. If six seconds after the ignition is completed, fire light goes out, indicating that there is no point ignition, the ignition switch-off point, the re-lighting. Such as the two ignition unsuccessful, stop the ignition, check the gas supply is normal, ignitor ignition position and combustion air and gas oil ratio, when general ignition, combustion air should be turned down. Check and after troubleshooting, the first purge re-ignition. 3. When work alarm function will mute switch is in the open position, when the combustion, halfway suddenly broken fire or repeatedly unsuccessful ignition, combustion controller automatically burn off valve, and the police. If no alarm sound, you can mute switch is in the off position.