Copper wire drawing oil | Indira Trask chemicals (certified) | copper wire drawing oil

 Processing copper wire drawing oil products waste processing 6 copper wire drawing oil waste including breaking and water purification steps. Demulsification mainly to the two-phase separation of oil and water, the principle is added to the emulsion containing Ca2 +, Na +, salts of the compounds of Al3 + and other metal ions, so that the emulsion of a surfactant thereto to form insoluble soaps, thus creating cohesion. In the use of sodium chloride and potassium aluminum sulfate being preferred. follows first emulsion into 2m3 or 3m3 of waste production tank, the PH value is adjusted to 6.5 to 7.5 copper wire drawing oil, waste liquid was added 2% to 5% sodium chloride, by mixing melted 2h, then added to 1% to 3% of the amount of waste aluminum potassium sulfate After the cleaning agent in Shenzhen, stir until dissolved, still 24h, wait until the condensation stratification, the lower part of the release of wastewater, chemical oxygen demand (COD) and oil content should be less than the national emission standards on the part of the condensate separation do fuel handling low cost of this treatment, not only to reach the water purification purposes, but also recycling, reduce production costs, reduce environmental pollution, and to get some money. Check the visual inspection of drawing oil, drawing oil is orange-red or tan uniform viscous fluid, no mechanical impurities insoluble copper wire drawing oil Changzhou, check long enough copper to use sampling in the end portion, to avoid precipitation anomalies are not found to be close to normal odor lubrication soybean oil mixed with the smell fishy, ??rancid if it is judged whether unqualified stratification (ie, whether the separation of oil and water) to check, take the appropriate drawing crude oil, formulated with disposable plastic cups, the ratio of the concentration was maintained at pull-up or pull a small level, preparation of the water with tap water. Fat content detection sugar meter. Tonggan do with a stirring rod stir and soak in the cup, after standing at room temperature 24h36h72h observe its performance results, without hierarchical status, eligibility is determined, if there is a situation of the oil-water separation stratification, the penalty failed. (Of course, to consider drawing oil and water quality adaptability) plant ester type, copper wire drawing oil lubrication excellent Xiangtan, applicable to all types of high speed wire drawing machine and a long drawing machine. Excellent biological stability, long life. Clean and good performance, suitable for surface require bright, uniform tin enameled wire and single-head machine. Best antioxidant properties, copper light. Excellent defoaming. Readily biodegradable, environmentally friendly liquid typical physical and chemical properties Appearance: amber colored transparent liquid = 5% emulsion: a stable milky liquid density (15.5 ℃, g / cm3): 0.95-0.97 pH value (3%, distilled water with liquid) :. 5-9.5 refraction coefficient: 1.0 copper wire drawing oil | Indira Trask chemicals (certified) | copper wire drawing oil provided by Indira Trask Chemicals (China) Limited. Indira Trask Chemicals (China) Co., Ltd. (www.delaska.com) Guangdong Shenzhen, oil (fat) leader, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Indira Trask chemicals in leadership with the staff warmly welcome all inquiries negotiations to create Indira Gdansk chemicals a better future.