Steel box girder template price | jiaocheng steel template | wenshui Unitas steel formwork

 1) due under the relevant provisions "of concrete structures construction and acceptance of norms" to be calculated and in combination. (2) a combination of steel formwork allowable stress of the material used should be chosen in accordance with the provisions, but also according to recency combined steel template, load the nature and structure, to be multiplied by a factor 1-1.25. 2. With board design (1) should be large steel template for the motherboard, and other specifications are as a supplement. (2) drawing board with a map of the location of steel should templates, models and the number of marked out, so that when you view clear. (3) In general, steel template with board, should be determined according to the size and shape of the mold surface with support form. 3. The arrangement of the support system (1) a support system, should be arranged according to the template of the load, and stiffness of these parts. (2) If the template is flush with the side seam layout, so every piece of steel template should be two points of support, and to be staggered, but the pitch is not restricted side seam locations. (3) support system should have sufficient strength and stability. 4. Check Acceptance (1) fasteners, for pulling bolts, steel flute, struts, braces, etc. These parts or components, to conduct inspections to check the number of focus points and fastening, not sloppy. (2) should be checked for embedded parts hollow plate girder steel template, and so there are some holes reserved. (3) The structure of the template, should have good stability. 1. It should be noted quality issues (1) reinforced the position to be calibrated, the position at the bottom of the pillar to be accurate, should be based on the size and height of the column section to design hoop size and spacing between columns. (2) beams, plates template should have a certain strength and stiffness, to be able to bagging, but not too much about the degree. (3) on the beam template, should the locking rod, so that deformation can be prevented catchy. 2. The product protection (1) template when gently lifting, can not have a collision, to prevent deformation of the template. (2) removal of the template can not use excessive force when, in order to avoid causing damage. (3) Remove the steel template to be checked and, if the problem should be resolved without delay. 3. Safety Measures (1) templates and fittings shall be qualified in accordance with the instructions when installing or operating regulations were not allowed to change. (2) the installation template and brackets, must be temporarily fixed facilities, to prevent overturning. (3) If the mounting height of over two meters template, then the platform or scaffold erection should work. (4) When installing the template down someone collusion with each other, non-air throw objects. Composite steel prices (5) met five or more wind, lifting operations can not be performed. (6) the vertical height of more than two meters when the template steel template, can not stand up assembling the upper lower template template. (7) when the tilt angle of a certain railway bridge steel template, to ensure the stability of the fulcrum, and to anti-slip measures. (8) can not exceed the load using templates. (9) on the brackets and accessories have to bear the load, it can not easily be moved or removed. Steel box girder template price | jiaocheng steel template | wenshui Unitas steel template provided by the text of water Unitas steel formwork Limited. Wenshui Unitas steel formwork Limited (www.jlgmb.com) strong, credible, Shanxi Luliang stainless steel products and other industries and has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead wenshui Unitas steel formwork and you hand in hand into the brilliant, for a better future!