Zhuhai factory direct ECM epoxy repair mortar

2014 special chemical acid brick clay manufacturers latest offer ECM epoxy repair mortar (acid epoxy clay), corrupted patch use. Factory Direct Tel: 18701680253 Kongqing Yao QQ: 454964868 welcome to inquire or to visit the company! Product Features 1, with impermeability, frost, salt, alkali resistance, weak acid corrosion resistance, and a variety of materials with strong adhesive force. 2, the thermal expansion coefficient close to the concrete, it is difficult to disengage from these substrates to be bonded and durability. 3, in the wet substrate surface construction, without dry, hardened in wet conditions or underwater. 4, easy to operate construction, with ordinary cement mortar construction, easy to clean, it can be cleaned with water. Applications 1, applies to the cellular surface of concrete structures, loopholes and flaws exposed tendons and other processing. 2, concrete structures, stair stepping corrupted patch. 3, sticky layer made of steel reinforcement and leveling when sticky carbon fiber reinforcement. 4, can be used as water, saline areas and chemical plants and other corrosive environments, corrosion-resistant materials. 5, for pasting acid brick. Technical parameters Detection Project Performance test results flexural strength (Mpa) 28d 6.0 6.49 Compressive Strength (Mpa) 7d ---- ≥25 28d> 20 35 neutral resistance (mm) 28d <5.0 1.8 bond strength ( Mpa) at room temperature normal 28d> 1.0 2.8 thermal cycling 28d> 1.0 2.4 permeable amount (g) <20 15 24h water absorption (g / m3) <1000 525 absorption coefficient (kg / cm3 h0.5) <0.5 0.32 Note?: Recommended Reference dosage: 1700kg / m3 Use 1, check the product packaging intact, check the label is correct. 2, open the lid, the pre-dosing bucket 3 bags marked A, B, C are removed. 3. A material, B material after shaking, were poured into the bucket and stir evenly, then marked with a "C" for stirring the powder into the barrel slowly, stirring into a uniform mortar like you can. If more viscous or difficult to stir, this package can be added to 1-2kg of clean water and stir, does not affect the final performance of the product mixture. Note 1, the product of cement-based materials, it is completely curing time required 28 days. 2, the FDA 24 hours can be carried out under a process. 3, marinated epoxy mortar should be used up within two hours, during this time, such as thickening of the situation appears to dry you can add the appropriate water and stir well before using. Packaging and storage 1, the product packaging specifications 20kg / barrel. 2, unopened shelf life of 12 months, may continue to be used after passing beyond the shelf life is subject to inspection. 3, non-toxic, odorless, non-flammable, non-explosive, in line with environmental protection requirements, according to general cargo storage and transportation. Responsible for any loss due to incorrect use caused by a solemn declaration of the Company department. Follow the instructions manual construction progresses, relevant questions, please consult your local dealer or our technical service department.