Maintenance and sheep breeding fodder balers 5552 type coating machine

Connection WT 5552 Silage round baler Diesel: Diesel match should be selected is greater than or equal to 8 horsepower, equipped with input speed shall comply with the requirements of the machine (the machine rated speed of 350 rev / min). The diesel engine is good solid, with four B-belt pulley connected to the machine, to complete the connection work (Note: machine without attachments, but providing services). . Feeding rack transport connections: the right side of hub (1) put into the rack transport right suspension inner frame, mounted on retainer locking. (2) the delivery of the left rack hanger and left panels together, the left wall hanger and left together, and then install the retainer and tighten the locking screw top. (3) on the belt, tensioner spring to hang the belt tensioner. Operation points: A, operating manual must be familiar with. B ﹑ connect the power, by the one person you push back the clutch lever, one control switch power switch is turned on for about 10 seconds, and immediately separated; check the motor rotation direction is consistent with the requirements of the machine. This machine is strictly prohibited reversed. C ﹑ before using this machine should be running empty five minutes, each chain parts, moving parts, pick up the feeder should add a little oil, and make adequate lubrication. D, according to the instructions threading indication map, put a rope, twine tensioner regulate the pressure, not too tight or too loose. E To improve productivity, by two people to operate the machine, one feed, one person out of the material to the front of the machine and is responsible for feeding. Two and a half hours to replace a job. F, the material is to be uniform, not once over-feeding, especially when the bale is almost full. G, the signal round uniform rotation, you can flip the winding clutch handle to begin tying rope around; at the same time give a small part of the material, in order to quickly put a rope into the bale. After the bale twine fast synchronous rotation, release the clutch lever. At this point the operator should pay attention to three points: ① winding roll if fodder, should clear out; ② winding roll if not into the rope belt can be easily loosened by hand under the rope, then pulled a clutch lever delivery line roping; ③ clutch lever to be pulled quickly, not slowly pulled, otherwise damage the clutch gear. H, hemp rope around one week back and forth, hitting the knife and cut off, stop feeding the rope. At this point the operator can lift the opening handle, opening the bundle. Another man pulled the bale and help CLOSE.