Briquette stick machine, Zhengzhou Light Mao Machinery (certified), coal bar machine

 Coal stick machine main points: 1, the need to temporarily stop work (usually no more than two hours), stop former requires adequate water to ensure that the water content in the 15 percent to about 20 percent in order to avoid downtime go inside the barrel during water loss, dry materials for the next smooth start. 2, when the result of downtime after a reboot, if unsuccessful should stop twice to start to start, check the cause and troubleshoot or remove the material before starting the machine. If forced to start it may cause damage to the equipment. 3, the current is the main parameter to measure the equipment load and degree of coal stick tight squeeze, is the main basis for the operator to control the device. There are two methods to adjust the current: adding water or adjusting the amount of coal to the feed port. 4, the operator should always pay attention to the material circumstances of rods coal feeding the mouth, and when there is a lot of material in the hopper to reduce churn should pay attention to quantity, but try not to pay attention to cutting, to avoid the spray material phenomenon. If the excessive accumulation of materials inside the bucket should be within the material with a thin bamboo stick stabbed machine (with an iron bar or prohibit excessive hardness tool poke materials). 5, if the head squeeze thirty percent more coal hole hole blocked when not stick the new ramjet coal stick machine, you should head down to remove the blocked drain hole before you continue. 6, when the replacement of worn pusher propeller Gongyi coal rods machine, the installation should be placed near one end of the new bearing housing, and the wear on the impeller by the smaller end of the handpiece. 11, feeding the housing and bearing connection end with the isolation chamber, avoiding material directly into the bearings and mechanical damage. When a small amount of material passing through the membrane into the isolation chamber should be promptly discharged through the lower part of the material discharge hole, the class must ensure that clean-up once. MBJ-300 briquette stick machine introduced MBJ-300 coal bar machine is the main equipment screw extrusion machine coal coal rods stick machine manufacturer, the rotating impeller people from feeding port folder coal and coal forward, coal gradually compression, the particles tightly close, while a relatively large agitation and mixing. In this case between the coal particles, the particles between the vane and simplified a strong friction and shear, while under the action of heat generated, the temperature rise of coal, water and a binder more uniform coal plasticity also greatly increased, then after moderation effect of cone molds, compression between coal particles more closely, and then pressed into the mold of the straight parts of the coal bar machine and molding. Briquette stick machine, Zhengzhou Light Mao Machinery (certified), coal bar machine provided by Zhengzhou City Light Mao Machinery Manufacturing Company Limited. Zhengzhou City-mao Machinery Manufacturing Co., Ltd. (www.gmjxzz.com) is a leader in Zhengzhou, industry-specific equipment, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Zhengzhou Light Mau leader in mechanical staff warmly welcome all inquiries negotiations to create a light-mao Machinery Zhengzhou a better future.