Lijiang metal hydraulic baler manufacturer manual baler price

"Rong Xing" brand straw baler is suitable for all kinds of straw, twigs, grass, paper packaging, cotton packing, garment packing, straw packaging, plastic packaging, medicine packaging, wool packaging, recyclable waste packaging, should be applied to cotton, wool, paper boxes, paper plates, yarn, tobacco, plastic, cloth, woven knit cashmere, linen, sacks, tops, wool balls, silk, hops, waste bags and all light bulbs, wire, copper strips, loose material, such as soft aluminum materials packaged class, greatly reducing the volume and increase the density, easy to transport and storage, is utilization, development of biomass energy effective helper compression. Note: eliminating the dealers, direct contact with the user, reducing the cost, time truly factory discounted prices. Model Pressure / T cylinder number / branch supporting the power / kw Dimensions / cm Price / Yuan YD-10 10 1 10 1300 * 900 * 3100 9200 YD-20 20 2 13 1600 * 900 * 3100 9800 YD-30 30 3 13 1700 * 1000 * 3100 11500 YD-60 60 2 13 1700 * 1000 * 3100 13500 balers structural principle: hydraulic balers include a housing with a floor and front and rear side of the baffle, jack mounted on the bracket, with a jack rod, the right vertical rod connected pusher plate pusher plate is connected to the right side pusher slats, the slats adjacent pusher gap between the board wearing rope groove; upper right portion of the bracket with a binder on the bezel, the bezel above the binder on the left side of the bracket with the inlet; fixedly connected on the front side of the crosspiece of the bracket on the right front side of the bezel, respectively, and a gap between the adjacent side of the crosspiece drawstring mouth; holder with the right end of the discharge port, the discharge port of the stent at the right end of the hinge with the door, the door is connected to the left side surface of the door, and a gap between the adjacent door of the door through the rope groove; front side cover, pusher plate and the bottom of the cavity is surrounded feed chamber, front and rear side of the crosspiece, press material on the bezel, door panels and floor enclosed cavity material for extrusion chamber; door and stand right end fixedly connected with a locking device, and may be within a certain range according to need to adjust the size of the package.